User manual HUSQVARNA 954140106B

[. . . ] LTH120 Owner’s Manual SAFETY RULES Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. I. GENERAL OPERATION • Read, understand, and follow all instructions in the manual and on the machine before starting. • Only allow responsible adults, who are familiar with the instructions, to operate the machine. [. . . ] • Keep battery and terminals clean. • Recharge at 6-10 amperes for 1 hour. NOTE: The original equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary. TO CLEAN BATTERY AND TERMINALS Corrosion and dirt on the battery and terminals can cause the battery to “leak” power. • Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor. • Rinse the battery with plain water and dry. • Clean terminals and battery cable ends with wire brush until bright. • Coat terminals with grease or petroleum jelly. • Reinstall battery (See “REPLACING BATTERY" in the SERVICE AND ADJUSTMENTS section of this manual). 11) • • • Raise mower to highest position to allow access to blades. Remove hex bolt, lock washer and flat washer securing blade. Install new or resharpened blade with trailing edge up towards deck as shown. BLADE MANDREL ASSEMBLY CENTER HOLE TRAILING EDGE UP FLAT WASHER HEX BOLT (GRADE 8)* LOCK WASHER *A GRADE 8 HEAT TREATED BOLT CAN BE IDENTIFIED BY SIX LINES ON THE BOLT HEAD. 11 CUSTOMER RESPONSIBILITIES V-BELTS Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. Replace belts if they begin to slip from wear. • • • After oil has drained completely, replace oil drain plug and tighten securely. Refill engine with oil through oil fill dipstick tube. For approximate capacity see “PRODUCT SPECIFICATIONS” section of this manual. Use gauge on oil fill cap/dipstick for checking level. Be sure dipstick cap is tightened securely for accurate reading. Keep oil at “FULL” line on dipstick. OIL FILL CAP/DIPSTICK TRANSAXLE COOLING The fan and cooling fins of transmission should be kept clean to assure proper cooling. [. . . ] 96-101) NOTE: All component dimensions given in U. S. inches 1 inch = 25. 4 mm 41 REPAIR PARTS TRACTOR - MODEL NO. 954 14 01-06 MOWER LIFT 7 8 5 13 4 6 11 12 13 19 13 20 2 3 1 6 5 4 15 31 32 13 31 32 20 17 18 16 20 19 20 15 42 REPAIR PARTS TRACTOR - MODEL NO. 1 2 3 4 5 6 7 8 11 12 13 15 16 17 18 19 20 31 32 PART NO. [. . . ]