User manual HUSQVARNA 96071001600

[. . . ] WARNING: In order to prevent acThese operators should evaluate their ability to operate the cidental starting when setting up, riding mower safely enough to protect themselves and others transporting, adjusting or making refrom serious injury. pairs, always disconnect spark plug wire and place wire where it cannot • Follow the manufacturer's recommendation for wheel weights contact spark plug. • Keep machine free of grass , leaves or other debris build-up which can touch hot exhaust/engine parts WARNING: Do not coast down a hill and burn. Do not allow the mower deck to plow leaves in neutral, you may lose control of the or other debris which can cause build-up to octractor. [. . . ] Do not mow in reverse unless absolutely necessary. Always look down and behind before and while backing. Never carry children, even with the blades shut off. They may fall off and be seriously injured or interfere with safe machine operation. Children who have been given rides in the past may suddenly appear in the mowing area for another ride and be run over or backed over by the machine. Keep children out of the mowing area and in the watchful care of a responsible adult other than the operator. Be alert and turn machine off if a child enters the area. Before and while backing, look behind and down for small children. Mow up and down slopes (15° Max), not across. Be alert and turn machine off if a child enters the area. Choose a low ground speed so that you will not have to stop or shift while on the slope. CAUTION: BEFORE ASSEMBLING GRASS CATCHER TO TRACTOR: • Depress clutch/brake pedal fully and set parking brake. • Place gearshift/motion control lever in "NEUTRAL" position. • Place attachment clutch in "DISENGAGED" position. • Turn ignition key "OFF" and remove key. • Make sure the blade and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. 4 ASSEMBLY 1 BAGGER SUPPORT ASSEMBLY (See Fig. Slide flanges of support assembly into drawbar slots first, then, pivot backwards inserting pin into drawbar pin hole. Be sure support assembly is seated properly, then secure with retainer spring. SUPPORT ASSEMBLY 02051 3 CONTAINER ASSEMBLY (See Fig. Place bottom half inside of top half, as shown. Place one foot inside bottom half and lift top half to meet bottom half. [. . . ] • Clean unit thoroughly after each use. STORAGE When grass catcher is to be stored for a period of time, clean it thoroughly, remove all dirt, grass, leaves, etc. CAUTION: Do not leave grass in bagger containers. Empty containers after each use and before storing. Failure to do so may result in spontaneous combustion which could develop into a fire. BLADE CARE For best results mower blades must be kept sharp. [. . . ]