User manual HUSQVARNA 96071002100

[. . . ] WARNING: Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. Operate only at the lowest possible speed when on a slope. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor. • • Data indicates that operators, age 60 years and above, are involved in a large percentage of riding mower-related injuries. [. . . ] Children who have been given rides in the past may suddenly appear in the mowing area for another ride and be run over or backed over by the machine. • Keep children out of the mowing area and in the watchful care of a responsible adult other than the operator. • Be alert and turn machine off if a child enters the area. • Before and while backing, look behind and down for small children. • Mow up and down slopes (15° Max), not across. • Be alert and turn machine off if a child enters the area. • Choose a low ground speed so that you will not have to stop or shift while on the slope. • Avoid starting, stopping, or turning on a slope. If the tires lose traction, disengage the blades and proceed slowly straight down the slope. • If machine stops while going uphill, disengage blades, shift into reverse and back down slowly. • Do not turn on slopes unless necessary, and then, turn slowly and gradually downhill, if possible. • Turn ignition key "OFF" and remove key. • Make sure the blade and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. 4 ASSEMBLY 1 INSTALL HIGH LIFT BAGGING BLADES (See Fig. Protect your hands with gloves and/or wrap blade with heavy cloth. 1. Slide flanges of support assembly into drawbar slots first, then, pivot backwards inserting pin into drawbar pin hole. Be sure support assembly is seated properly, then secure with retainer spring. SUPPORT ASSEMBLY 02051 IMPORTANT:To ensure proper assembly, center hole in blade must align with star pattern on mandrel assembly. 4. Install and tighten blade bolts securely (45-55 Ft. torque). STAR PATTERN INSERT FLANGES FIRST INTO DRAWBAR SLOTS 02543 BLADE BOLT (SPECIAL) 02 54 4 MANDREL ASSEMBLY HIGH LIFT BAGGING BLADE DRAWBAR PIN HOLE FIG. 1 3 MOUNTING COVER ASSEMBLY TO SUPPORT ASSEMBLY (See Fig. 3) 2 HANG SUPPORT ASSEMBLY ON REAR DRAWBAR (See Fig. [. . . ] • Before each use check for loose fasteners. • Clean unit thoroughly after each use. STORAGE When grass catcher is to be stored for a period of time, clean it thoroughly, remove all dirt, grass, leaves, etc. CAUTION: Do not leave grass in bagger containers. Empty containers after each use and before storing. [. . . ]