User manual HUSQVARNA 96091001601

[. . . ] TR430 Instruction manual Please read these instructions carefully and make sure you understand them before using this machine. 3 7 14 36 46 55 58 We reserve the right to make changes without prior notice. Be familiar with the controls and the proper use of the equipment; Never allow children or people unfamiliar with these instructions to use the machine. Local regulations can restrict the age of the operator. [. . . ] Keep a firm grip on the starter handle and let rope rewind slowly. Do not let starter handle snap back against starter. 6) and then move to fully opened position as engine warms up. 8) to the slow position for a few minutes to warm up engine. Keep drive control lever in "disengaged" position when starting the engine (fig. In order to idle smoothly, a new engine may require 3 to 5 minutes running time above slow idle speed. Idle speed has been adjusted to be correct after this break-in period. To begin tine movement, push down on the drive control release and squeeze the drive control lever to the "engaged" position (fig. Always release drive control lever before moving shift lever into another position. Releasing the drive control lever will disengage the drive control release. To start tiller movement, push down on the drive control release and squeeze the drive control lever (fig. Don't back yourself into a solid obstruction such as a tree, fence, etc. To stop engine, move throttle control (fig. 9) to slow position and allow the engine to run at low speed for 1 or 2 minutes before moving throttle to stop position. 9) slowly and return the handle to its original position when reistance is felt. This operation is necessary to prevent outside moist air from intruding into the combustion chamber. Lift handle to raise tines out of the ground (fig. Swing the handle in the opposite direction you wish to turn, being careful to keep feet and legs away from the tines. When you have completed your turn-around, lower the handle. place shift lever indicator in ( ) (tilling) position and move throttle control to desired speed. To begin tilling, push down on the drive control release and hold drive control lever against the handle. Inset B de h pt _s ta _ ke 1 19 13 14 15 16 17 Inset C 20 Outer side shields The back of the outer side shields (fig. [. . . ] Remove spark plug, pour one half ounce of clean engine oil into cylinder. Pull starter handle slowly several times to distribute oil. Clean entire tiller, especially cylinder fins, blower housing and air screen. Gasoline stored for several months will lose it's volatility (ability to burn effectively); therefore, always use up gasoline at the end of the season. [. . . ]