User manual HUSQVARNA 96091001800

[. . . ] Never work while people, especially children, or pets are nearby. Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. SICHERHEITSVORSCHRIFTEN SCHULUNG • • While working, always wear substantial footwear and long trousers. Do not operate the equipment when barefoot or wearing open sandals. [. . . ] (Do not use pressurized starting fluid, as severe internal engine damage may occur due to loss of lubrication. 5), use fresh, clean regular unleaded automotive gasoline. Starter handle Choke lever Spark plug wire Fuel Valve Shift lever indicator Drive control lever "disengaged" position Drive control lever "engaged" position Drive control release "unlocked" position Drive control release "locked" position Throttle control Handle grip a. 8) 1/3 of the way towards the high speed position. 6) with one hand and grasp handle bar with other hand. Pull rope out slowly until engine reaches start of compression cycle (rope will pull slightly harder at this point). Pull rope with a rapid, continous, full arm stroke. Keep a firm grip on the starter handle and let rope rewind slowly. Do not let starter handle snap back against starter. 6) and then move to fully opened position as engine warms up. 8) to the slow position for a few minutes to warm up engine. To start tiller movement, push down on the drive control release and squeeze the drive control lever. For cultivating move throttle control to desired speed. 2 6 7 1 Tilling 4 5 3 WARNING!Always release drive control lever before moving shift lever into another position. Releasing the drive control lever will disengage the drive control release. Tilling hints Tilling is digging into, turning over and breaking up packed soil before planting. Soil conditions are important for proper tilling. Tines will not readily penetrate dry, hard soil which may contribute to excessive bounce and difficult handling of your tiller. Hard soil should be moistened before tilling: however, extremely wet soil will "ball-up" or clump during tilling. Wait until the soil is less wet in order to achieve the best results. For easier handling of your tiller, leave about 8 inches of untilled soil between the first and second tilling passes. [. . . ] Do not store, spill or use gasoline near an open flame or devices such as a stove, furnace or water heater which utilize a pilot light, or devices that can create a spark. Throttle control 2 Figure 14 1 Maintenance schedule First 2 hours Before each use Every 5 hours Every 25 hours Every 50 hours Check engine oil level Change engine oil Oil pivot points Spark arrester muffler Inspect air screen Air cleaner Clean engine cylinder fins Replace spark plugs • • • • • • • • • • 40 4 Schmierplan Schmieren der Lagerspitzen 1. Handle can be positioned at different settings between "high" and "low" positions (fig. Select handle height suitable for you and your tilling conditions. [. . . ]