User manual HUSQVARNA 96191003001

[. . . ] Look for this symbol to point out important safety precautions. WARNING: Always disconnect spark plug wire and place it where it cannot contact plug in order to prevent accidental starting when setting up, transporting, adjusting or making repairs. WARNING: This snow thrower is for use on sidewalks, driveways and other ground level surfaces. Caution should be exercised while using on sloping surfaces. [. . . ] Throwing snow during a heavy, windy snowstorm can blind you and be hazardous to the safe operation of the snow thrower. 12 MAINTENANCE GENERAL RECOMMENDATIONS The warranty on this snow thrower does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must maintain snow thrower as instructed in this manual. Some adjustments will need to be made periodically to properly maintain your snow thrower. At least once a season, check to see if you should make any of the adjustments described in the Service and Adjustments section of this manual. • At least once a year, you should replace the spark plug and check belts for wear. A new spark plug will help your engine run better and last longer. • Follow the maintenance schedule in this manual. NOTE: Use only Original Equipment Manufacturer (OEM) parts to service this unit. Failure to do so can cause the unit to malfunction and pose a risk of injury to the operator. LUBRICATION CHART Maintenance section ➀ SAE 30 Motor Oil ➁ See “ENGINE” in ➂ General Purpose Grease ➀ Pivot points BEFORE EACH USE 1. Check controls to be sure they are functioning properly. LUBRICATION Keep your snow thrower well lubricated (See “LUBRICATION CHART”). grease fittings ➂ Auger ➁ Engine oil SNOW THROWER Always observe the safety rules when performing any maintenance. TIRES • Maintain proper air pressure in both tires (14–17 P . S. I. ). Remove safety ignition key and disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. Remove drain plug and drain oil in a suitable container. Install drain plug and tighten securely. Wipe off any spilled oil from snow thrower and engine. Install left wheel (if removed for draining oil). Be sure to install klick pin into proper hole in wheel axle (See “TO REMOVE WHEELS” in the Service and Adjustments section of this manual). Be careful not to allow dirt to enter the engine. Refill engine with oil through oil dipstick tube. For approximate capacity see “PRODUCT SPECIFICATIONS” section of this manual. Use gauge on oil fill cap/dipstick for checking level. Be sure dipstick cap is tightened securely for accurate reading. [. . . ] 35 REPAIR PARTS SNOW THROWER - - MODEL NUMBER PR6R24 (96191003001) BAG OF PARTS KEY NO. 169675 180684 73800600 19131316 192090 73800400 DESCRIPTION RETAINER PIN WRENCH LOCKNUT 3/8−16 WASHER 3/8 SHEAR BOLT 1/4−20 X 1−13/16 LOCKNUT 1/4−20 1 01. 14. 006-B 1 01. 14. 009-A KEY NO. 422663 DESCRIPTION SAFETY IGNITION KEY 1 3 2 4 1 4 2 2. 56 01. 14. 012-A KEY NO. 180445 187716 72270505 155377 DESCRIPTION SHIFTER ROD TOP SHIFTER ROD BOTTOM CARRIAGE BOLT 5/16-18 X . 75 NUT 5/16-18 NOTE: All component dimensions given in U. S. [. . . ]