User manual HUSQVARNA 966004001

[. . . ] Operator and Parts Manual GRASS CATCHER 42" 966004001 CONTENTS SAFETY RULES. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 GENERAL OPERATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 SLOPE OPERATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Frequently check components and replace with manufacturer’s recommended parts when necessary. • • • 5 SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS • Keep machine free of grass, leaves, or other debris buildup. Stop and inspect the equipment if you strike an object. Repair, if necessary, before restarting. Never make adjustments or repairs with the engine running. Grass catcher components are subject to wear, damage, and deterioration, which could expose moving parts or allow objects to be thrown. Frequently check components and replace with manufacturer’s recommended parts, when necessary. Wrap the blade(s) or wear gloves, and use extra caution when servicing them. Adjust and service as shown in the Operator’s Manual. WARNING! Battery posts, terminals and related accessories contain lead and lead compounds, chemicals know to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. • • • WARNING! DO NOT tow any trailers, etc. They may jackknife or over turn causing damage to the mower and possibly serious injury to the operator. • • 6 UNPACKING INSTRUCTIONS • • Remove all parts and packing materials from carton Check carton contents against list. Be sure all parts are there. 9 CONTAINER CONTENTS 2 - Soft bag containers 1 - Upper Chute 1 - Cover Assembly 1 - Weight 1 - Bag of Hardware 1 - Lower Chute 1 - Mounting Hardware TOOLS REQUIRED ½" Wrench (2) 7 /16" Wrench (2) Drill 9 /16" Socket and Ratchet Standard Screwdriver /16" Wrench (2) Ft/Lbs Torque Wrench ¼" and 5/16" Drill Bits PARTS IDENTIFICATION UPPER CHUTE COVER ASSEMBLY LOWER CHUTE BAG CONTAINERS NOTE: When right hand (RH) and left hand (LH. are mentioned in this manual, it means when you are seated on the mower in the operator’s position. CAUTION BEFORE ASSEMBLING GRASS CATCHER TO MOWER: • • • • • Set parking brake. Place motion control levers in “NEUTRAL” position. Turn ignition key “OFF” and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug and place wire where it cannot come in contact with plug. 7 ASSEMBLY 1 INSTALL PLATE AND HANGER 2 MOUNTING COVER ASSEMBLY TO SUPPORT ASSEMBLY 1. Using hardware provided in kit, attach support mount to unit. 2. Attach hanger bracket to support mount. Do not fully tighten nuts at this time. For ease of assembly, you may wish assistance from another person for mounting the cover assembly to mower. 1. Position cover assembly on the ground behind the mower. 2. Lift and rotate cover to align the frame bracket with the hanger and slide the cover down until secure. Cover Assembly Support Mount Hanger Bracket 3. Secure rear end of support straps to outside of hanger assembly. Set reinforcement plates to the outside of the tank brackets and fasten front end of support strap to tank bracket and reinforcment plate with round head bolt. [. . . ] Lifetime Warranty (“PARTS ONLY” after initial warranty expiration): Ignition coils and modules on handheld product. Proof of purchase required. SECTION 2: HUSQVARNA S OBLIGATIONS UNDER THE WARRANTY SECTION 3: ITEMS NOT COVERED BY THIS WARRANTY The following items are not covered by this warranty: Husqvarna will repair or replace defective components without charge for parts or labor if a component fails because of a defect in material or workmanship during the warranty period. (1) Normal customer maintenance items which become worn through normal regular use, including, but not limited to, belts, blades, blade adapters, bulbs, clutches, clutch drums, filters (fuel line, fuel filters, air filters, oil filters), sprockets, guide bars, lubricants, rewind springs, saw chain, spark plugs, starter ropes and tiller tines; (2) Natural discoloration of material due to ultraviolet light; (3) Engine and drive systems not manufactured by Husqvarna; these items are covered by the respective manufacturer s warranty as provided in writing with the product information supplied at the time of purchase; all claims must be sent to the appropriate manufacturer. (4) Lawn and garden attachments that are covered by a third party which gives a warranty, all claims for warranty should be sent to the manufacturer. (5) Commercial or consumer mowing decks with sand abrasion damage. [. . . ]