User manual HUSQVARNA 966415901

[. . . ] 6 SERVICE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Container Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Assembly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Use extra care when approaching blind corners, shrubs, trees, or other objects that may obscure vision. The operation of any mower can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your mower or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses. • Use extra care in handling gasoline and other fuels. They are flammable and vapors are explosive. - Never remove gas cap or add fuel with the engine running. - Allow engine to cool before refueling. - Never store the machine or fuel container inside where there is an open flame, such as a water heater. Never run a machine inside a closed area. Keep nuts and bolts, especially blade attachment bolts, tight and keep equipment in good condition. Do not turn on slopes unless necessary, and then, turn slowly and gradually downhill, if possible. CAUTION In order to prevent accidental starting when setting up, transporting, adjusting or making repairs, always disconnect spark plug wire and place wire where it cannot contact spark plug. • • • • • • WARNING Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. • • • • CAUTION Look for this symbol to point out important safety precautions. YOUR SAFETY IS INVOLVED. WARNING Battery posts, terminals and related accessories contain lead and lead compounds, chemicals know to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. 7 UNPACKING INSTRUCTIONS • • Remove all parts and packing materials from carton. ½" Wrench (2) 9 9 CONTAINER CONTENTS 3 - Soft Bag Containers 1 - Lower Chute 1 - Cover Assembly 1 - Catcher Mount 1 - Upper Chute 1 - Catcher Hitch 1 - Cast Weight Hardware TOOLS REQUIRED • • • • /16" Wrench /16" Socket wrench Drill and 5/16" bit PARTS IDENTIFICATION COVER ASSEMBLY UPPER CHUTE DUMP BAG INDICATOR CHUTE LATCH LOWER CHUTE BAG CONTAINERS NOTE: When right hand (RH) and left hand (LH. ) are mentioned in this manual, it means when seated on the mower in the operator’s position. CAUTION BEFORE ASSEMBLING GRASS CATCHER TO MOWER: • Place motion control levers in “NEUTRAL” position. • Turn ignition key “OFF” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug and place wire where it cannot come in contact with plug. 8 ASSEMBLY 1 BAGGER MOUNT - 2009 Models BAGGER SUPPORT -2008 and Prior Models Remove rear engine guard (if installed) by removing the six bolts that attach the guard to the frame. 1. Place hitch on the rear of the mower. Engine Guard Bolts Rear Engine Guard Engine Guard Bolts 1. Install the bagger mount tube to the rear guard with 5/16-18 x 3¼ bolts and flange nuts from kit. NOTE: Depending on model, rear guard hole may need to be drilled out to 5/16" if kit hardware is too large. 2. Install kit support straps on the outside of the mount tube as shown in the illustration. [. . . ] h. Reinstall containers making sure containers overlap left at center supports. i. Close cover and secure latches over center support tubes. • Avoid cutting wet grass or mowing in the morning while the dew is still heavy. Grass clippings collected under these conditions tend to be sticky and adhere to the walls of the flow path causing clogging. [. . . ]