User manual HUSQVARNA 966663801

[. . . ] Operator Manual P-ZT4822FS / 966613301 P-ZT6126FS / 966613501 P-ZT26FS BF / 966613701 P-ZT5224FS / 966613401 P-ZT6128BS / 966613601 P-ZT4822FS CARB / 966663801 Please read the operator manual carefully and make sure you understand the instructions before using the machine. Form Number 115 392427R1 10/19/10 To implement improvements, specifications and designs can be altered without prior notification. Note that no legal demands can be placed based on the information contained in these instructions. The use of other parts voids the warranty. Do not modify or install non-standard equipment to the unit without consent from the manufacturer. [. . . ] The bypass linkage is used when manual pushing or pulling the unit. See Manual Transport in the Operation section. 8065-097 Right side, ZT linkage 24 CONTROLS Refueling IMPORTANT INFORMATION It is recommended that fuel be added to both tanks on initial start up. Read the safety instructions before refueling. The machine has two fuel tanks, one on each side just behind the seat. The capacity for each tank is 5½ gallons (20. 8 liters). Regularly check the gas cap gasket for damage and keep the cap properly tightened. The engine will run on a minimum of 87-octane unleaded gasoline (no oil mix). Environmentally adapted alkylate gasoline can be used. See Technical Data concerning ethanol fuel. Damage to the engine and components may occur. When operating in temperatures below 32° F. (0° C. ), use fresh, clean winter grade gasoline to help insure good cold weather starting. 8065-007 Gasoline fuel tanks IMPORTANT INFORMATION Experience indicates that alcohol blended fuels (called gasohol, ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. See Storage Instructions for additional information. Never use engine or carburetor cleaners in the fuel tank or permanent damage may occur. WARNING!Observe caution and fill the tank outdoors (see the safety instruction). WARNING!The engine and the exhaust system become very hot during operation. Allow engine and exhaust system to cool before refueling WARNING!Do not store, spill or use gasoline near an open flame. 25 OPERATION Read the Safety Instructions section and the following pages if you are unfamiliar with the machine. To turn to the right While moving in a forward direction, pull the right lever back towards the neutral position while maintaining the position of the left lever, this will slow the rotation of the right wheel and cause the machine to turn in that direction. [. . . ] 2. Inspect the machine for worn or damaged parts and tighten any nuts or screws that may have become loose. 3. Change the engine oil; dispose of properly. 4. Empty the fuel tanks or add a fuel stabilizer. Start the engine and allow it to run until the carburetor is drained of fuel or the stabilizer has reached the carburetor. [. . . ]