User manual HUSQVARNA 966976201

[. . . ] 5 SERVICE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ASSEMBLY. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 OPERATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Be alert and turn off the machine if children enter the area. Before and when backing, look behind and down for small children. They may fall off and be seriously injured or interfere with safe machine operation. Use extra care when approaching blind corners, shrubs, trees, or other objects that may obscure vision. • • • Never run a machine inside a closed area. Keep nuts and bolts, especially blade attachment bolts, tight and keep equipment in good condition. Check there proper operation regularly. • CAUTION In order to prevent accidental starting when setting up, transporting, adjusting or making repairs, always disconnect spark plug wire and place wire where it cannot contact spark plug. 5 SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS • Keep machine free of grass, leaves, or other debris buildup. Stop and inspect the equipment if you strike an object. Repair, if necessary, before restarting. Never make adjustments or repairs with the engine running. Grass catcher components are subject to wear, damage, and deterioration, which could expose moving parts or allow objects to be thrown. Frequently check components and replace with manufacturer’s recommended parts, when necessary. 2. Place retainer on the outer pulley cover. 3. Align the tab end of the belt cover into the slot on the deck belt shield and the other end over the end of the outer pulley cover. 4. Secure with knob. Knob 1. Install the bagger mount tube to the rear guard with 5/16-18 x 3¼ bolts and flange nuts from kit. NOTE: Depending on model, rear guard hole may need to be drilled out to 5/16" if kit hardware is too large. 2. Install kit support straps on the outside of the mount tube as shown in the illustration. Using a 5 /16-18 x 1¼ bolt, attach the front side of the strap to the fender support. Place the reinforcement plate to the outside of the fender support. Secure with additional 1¼ bolt and fasten both bolts with flange nuts. NOTE: The front side of the kit support straps should be on the inside of the mower frame. 3. Tighten all hardware. Drill rear guard hole to 5 /16" if needed 7 INSTALLING BAGGER MOUNT Belt Cover Tab Middle Chute Latch Retainer Deck Belt Shield Reinforcement Plate Outer Pulley Cover 6 INSTALLING MIDDLE CHUTE Support Strap 1. Place middle chute over the top end of the blower assembly. 2. Latch middle chute to blower assembly. Middle Chute Blower Assembly Rear Guard Mount Tube 10 ASSEMBLY 8 INSTALLING CHUTE SUPPORT 1. Position upper chute support against bagger inlet, flush at outer edges. [. . . ] Normal wear, tear or abuse is not covered under warranty. All care and maintenance instructions must be followed as stated by the manufacturer on the care label. The fit of the protective apparel/boot is not covered under warranty. ****Battery 1 Year prorated limited warranty with 100% replacement during the first 6 months. Lifetime Warranty (Parts and Labor): All tiller tines and trimmer shafts against breakage. [. . . ]