User manual HUSQVARNA 967805518

[. . . ] Hold the head horizontally and put back the washer and nut with the 30 mm wrench (UK spanner) Warning: always check that the head spindle is inserted into the right hole for the disk used (lower hole for 300 Ø; upper hole for 350 Ø). Please make sure that the electric cables do not get pinched or caught. 3- Tilt the head of the machine to clear the centering pin. PREFACE TO THE MANUAL Before leaving our factory every machine passes an exacting inspection programme in which everything is checked minutely. [. . . ] The use of symbols on machines (in color) and in the manual identify advice concerning your safety. Blue background, white marking : obligatory safety + red marking : movement forbidden Black triangle and marking on a yellow background : danger if not adhered to. Risk of injury to the user or third parties, with possibility of damage top the machine or the tool. Red circle with or without bar : use or presence prohibited. Information - Instruction: special instructions concerning use and inspection. The manufacturer declines any responsibility resulting from improper use, or modifications. This symbol indicates that the machine is in conformance with the applicable European directive. The disc cutter is designed to provide safe and reliable service in operating conditions corresponding with the instructions, but it can present dangers for the user and risks of damage, consequently regular on site inspection is necessary to ensure : · Perfect technical condition (use for the purpose for which it is intended and taking into account any risks, and correction of any malfunction detrimental to safety). Use of a diamond disc for water lubricated cutting of marble, stone, granite, brick and facings (porcelain, glazed tiles, ceramics, etc). The use of any other disc is forbidden (abrasive, saw, etc). Competent personnel (qualifications, age, training, education) who have studied the manual in detail before starting work: any fault of an electrical or other nature must be checked by a competent person (electrician, maintenance foreman, authorized dealer, etc). Take care about the direction of rotation which is shown by an arrow on one of the faces. Make sure the contact faces of flanges, of blade and the axle are clean. Operate this machine only on a supply equipped with a 30 mA earthed current-limit i n g c i r c u i t - b r e a k e r. o t h e r w i s e , consult our catalogue for appropriate models. - The RCCB must be used correctly, including testing it regularly. For tools supplied with an integral RCCB in the cable or in the mains plug, if the cable or plug has been damaged, repairs must be carried out by the manufacturer, one of his agents or by a qualified repair workshop to avoid any risks resulting from errors. Straight cuts 510 mm : the stop (C) prevents fingers being trapped between the table and the frame (SEE FIG 8). The machine is set before leaving the factory and no adjustment is necessary. Maintenance (the motor must be stopped) 13 Important advice Drain the tank frequently to remove cutting residue, which otherwise could block the pump and cause it to wear out prematurely. Carefully clean the contact faces for the table rollers. Store in a dry place, not accessible to children. [. . . ] As part of our product quality improvement policy, we reserve the right to make any and all technical modifications without prior notice. VARNING Trekant och svart markering på gul bakgrund: fara vid förbiseende, risk för personskador för användaren och tredje part, risk för maskinskada eller verktygsskada. Denna kapmaskin har tillverkats för att tillförsäkra en trygg och säker användning för användningsförhållanden enligt instruktionerna, och kan innebära en fara för användaren samt risker för förstörelse, och därför krävs regelbundna Denna bruksanvisning skall alltid finnas kontroller på arbetsplatsen för att se till att: till hands på arbetsplatsen. Arbetsområdet ska vara väl upplyst och i ordning och får inte utgöra någon risk (fukt eller närhet till farliga produkter får inte förekomma). [. . . ]