User manual HUSQVARNA CARDINAL 6310

[. . . ] Repair instruction Description: C4 Flush mechanism Part number: 21066 Inlet tube / 20292-62 Flush tube / 21065 Bellow/2029162 Flush mechanism Look for Service Centers, Point of Sale addresses and other information on: www. 21066 Inlet tube / 20292-62 Flush tube / 21065 Bellow A Lift the flush cap up with your finger (1) 1. B Push cylinder (2) down and turn it to the left to take it out. After this, the bellow cap (3) and housing (4) can be taken out. [. . . ] If the vent button has to be replaced, please follow underneath instructions. Note : Press the vent button in while assembling the new seal retainer. Place vent plug back into the waste tank and turn the two arrows back to each other Leaflet no. Com Version: Date: Tools required: 1 April 2010 - A Turn automatic vent and take it out completely. B Press upper automatic vent in, so that the foam can be taken off. C 23380 Follow steps in reverse for assembling the new seals. 1/1 04/10 Repair instruction Description: SC200 Lock waterfill door Part number: 23790-57/58/80/84 Look for Service Centres, Point of Sale addresses and other information on: www. After this, take two screws out of the housing. C Take housing off and complete lock out. D For assembling new lock, follow steps in reverse. 23384 1/1 04/10 Repair instruction Description: SC200CW Pump retainer Part number: 23845 Look for Service Centres, Point of Sale addresses and other information on: www. B To allow the kit becomes loose, use a flat screwdriver. note: Place a towel between the watertank and flush mechanism to avoid damages. 23381 1/2 04/10 C Make the vacuum breaker loose from the pump by pressing the clip. Take now complete pump out of the watertank. E Press pump retainer loose from the pump, is connected on three points. Place new pump retainer and press it back onto the pump. F For assembling the complete pump back into the watertank, follow the steps in reverse. 23381 2/2 04/10 Repair instruction Description: SC200 Saddle bracket Part number: 23848 Look for Service Centres, Point of Sale addresses and other information on: www. Com Version: Date: Tools required: 1 April 2010 Cross headed screwdriver A Remove waste holding tank out of the toilet. B Take 3 screws out of the saddle bracket. C Push retaining ring, which is holding the bracket and shaft together loose. [. . . ] place new level indicator in reverse steps. 0312 Repair instruction Description: SPP Electric Pump Excellence Part number: 92402-07/135 Look for Service Centres, Point of Sale addresses and other information on: www. Com Version: Date: Tools required: 1 March 2012 Flat screwdriver A Remove seat & cover B Turn battery housing and remove from pump housing. C Place flat screwdriver in holes pump housing, turn housing and pull housing out of the water tank. [. . . ]