User manual HUSQVARNA CTH163T

[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. We reserve the right to make changes without prior notice. Be familiar with the controls and the proper use of the equipment. ⷠNever allow children or people unfamiliar with the instructions to use the lawnmower. [. . . ] Do not run the start motor more than 5 seconds at once. If the engine will not start, wait about 10 seconds before the next try. Let the ignition key return to the "ON" position when the engine has started Push the gas control to the required speed. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless absolutely necessary. uSING THE ROS · With engine running, turn ignition key counterclockwise to ROS "ON" position. ⷠLook down and behind before backing. When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position. Clear the lawn from stones and other objects which can be thrown away by the blades. localize and mark stones and other fixed objects to avoid collision. Begin with a high cutting height and reduce until the required cutting result is obtained. The cutting result is best with high engine speed (blades rotate quickly) and low gear (machine goes slowly). If the grass is not too long and thick the drive speed can be increased by selecting a higher gear or increasing the motor speed, without affecting the cutting result. the best lawn is achieved if the grass is cut often. Cutting becomes more even and the cut grass is more evenly distributed over the surface. Total time taken is not greater, since higher drive speed can be selected without affecting the cutting results. The cutting results will be worse since the wheels will sink into the soft lawn. Spray the cutting unit with water underneath after use. Your tractor is equipped with a Dump Bag Alarm. Raise dump handle to its highest position. Pull handle forward to raise bagger and dump clippings. ⷠTo continue mowing, be sure bagger is down and in proper operating position which will allow mower to operate. [. . . ] Engine and place the throttle lever in the Fast " IMPORTANT: Recheck the area making certain the area is clear. Remain in the operator's position with the cutting deck engaged until the deck is cleaned. Turn the ignition key to the STOP position to turn the tractor's engine off. Pull back the lock collar of the nozzle adapter to disconnect the adapter from the nozzle washout port. [. . . ]