User manual HUSQVARNA EXCLUSIVE 4000

[. . . ] This product is in accordance with applicable EC directives. Symbols on the product or its packaging indicate that this product cannot be handled as domestic waste. it must instead be submitted to an appropriate recycling station for the recovery of electrical and electronic equipment. By ensuring that this product is taken care of correctly, you can help to counteract the potential negative impact on the environment and people that can otherwise result through the incorrect waste management of this product. [. . . ] make sure that no drill slurry enters the machine. Water entering a power tool will increase the risk of electric shock. Ensure the cord is behind you when you start to use the machine so that the cord will not be damaged. The machine (Great Britain 120V) is not equipped with a ground fault circuit interrupter. The machine must always be used with an isolating transformer for protection in case an electrical fault should occur. Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electrtic shock, fire and/or serious injury. Work area safety Keep work area clean and well lit. cluttered or dark areas invite accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. There is always a risk of shocks from electrically powered machines. Avoid unfavourable weather conditions and body contact with lightning conductors and metal objects. Do not wash the machine with water, as water can enter the electrical system or the engine and cause damage to the machine or short circuit. Check that the cord and extension cord are intact and in good condition. use an extension cord intended for outdoor use. Never use the machine if any cable or plug is damaged, but hand it in to an authorized service workshop for repair. Do not use an extension cord while it is rolled up to avoid overheating. Use and care Carry out the checks, maintenance and service instructions described in this manual. Some maintenance and service measures must be carried out by trained and qualified specialists. see instructions under the heading Maintenance. Inspection and/or maintenance should be carried out with the motor switched off and the plug disconnected. [. . . ] Keep people and animals well away from the working area. Set the working speed by turning the drill spindle and at the same time move the gear knob to the required position. Power switch, cord and electrical outlet are intact. If not, they must be replaced by an authorised repairman. [. . . ]