User manual HUSQVARNA EZ17

[. . . ] Operator´s manual EZ 17 EZ 21 Please read these instructions carefully and make sure you understand them before using the machine. English TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Driving/Transporting on Public Roads . . . . . . 3 Towing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Clear the area of objects such as rocks, toys, wire, etc. , which could be picked up and thrown by the blades. · 8011-603 Mowing patterns · · · · 32-English OPERATION Stopping the Engine Allow the engine to idle a minute in order to attain normal operating temperature before stopping it, if it has been worked hard. Avoid idling the engine for longer periods, as there is a risk of the spark plugs fouling. 1. Disengage the mower deck by depressing the blade switch. 8011-668 Disengage the mower deck 2. 3. Raise the mower deck by depressing the pedal forward to the transport position. When the machine is standing still, activate the parking brake by pulling the lever backward. Move the throttle to the minimum position (tortoise symbol). Turn the ignition key to the stop position. Always remove key when leaving the mower to prevent unauthorized use. 4. 5. 6. 8011-718-2 Raise the mower deck with the pedal IMPORTANT INFORMATION Leaving the ignition switch in any other position than "OFF" will cause the battery to be discharged and the hour meter to accumulate hours. English-33 OPERATION Moving by Hand WARNING!No adjustments or maintance to be carried out unless: - the engine stopped, - the ignition key has been removed, - the parking brake is on. When pushing or pulling the mower, be sure to engage the IZT (Integraded Zeroturn Transaxle) bypass linkages. The IZT bypass linkages are located on the rear of the frame, below the rear engine guard. · Raise the deck into the highest cutting position. 1 2 CZ10-2 1. IZT Bypass linkage Bypass linkages · Pull the IZT bypass linkages out and into the slots and release so that it is held in the bypass position. To reengage the IZT's to drive, reverse the above procedure. · 1 2 CZ12 1. IZT Bypass linkage in bypass position Bypass position 34-English MAINTENANCE Maintenance Schedule The following is a list of maintenance procedures that must be performed on the machine. For those points not described in this manual, visit an authorized service workshop. An annual service carried out by an authorized service workshop is recommended to maintain your machine in the best possible condition and to ensure safe operation. Read "Maintenance" in the Safety Instructions section. 1) First change after 5-8 hours. When operating with a heavy load or at high ambient temperatures, replace every 50 hours. 2) In dusty conditions, cleaning and replacement are required more often. 3) For daily use, the machine should be lubricated twice weekly. 4) Performed by authorized service workshop. = Described in this manual = Not described in this manual Weekly At mainte- least nance once each Page Before After year Daily maintenance Maintenance interval in hours 25 50 100 300 Maintenance Check the parking brake Check the engine's oil level (every refueling) Check the safety system Check for fuel and oil leakages Check/clean the engine's cooling air intake Check the mower deck Check hardware (screws, nuts, etc. ) Clean under the mower deck Start the engine and blades, listen for unusual sounds Check for damage Thoroughly clean around the engine Clean around belts, belt pulleys, etc. Check the tire pressures Check battery Sharpen/Replace mower blades Check the fuel pump's air filter 2) Clean the engine's cooling air intake 2) Clean the air cleaner's pre-filter 2) (foam) Clean the air cleaner's filter cartridge (paper filter) Check/adjust the parking brake Inspect muffler/Spark arrester 2) 53 57 39 40 47 52 51 43 37 47 43 40 42 42 - English-35 MAINTENANCE Weekly At mainte- least nance once each Page Before After year Daily maintenance Maintenance interval in hours 25 50 100 300 Maintenance Check/adjust throttle and choke cables Check the condition of belts, belt pulleys, etc. [. . . ] The need and advantages of leaving the machine for service every 300 hours. The effects of service and maintaining a service journal on the machine's resale value. Certified: English-69 SERVICE JOURNAL After the First 5-8 Hours 1. Change engine oil. 70-English SERVICE JOURNAL Action Date, mtr reading, stamp, sign 25-Hour Service 1. [. . . ]