User manual HUSQVARNA EZ5224

[. . . ] Operator’s Manual EZ4624 / 968999657, EZ5226 / 968999658 EZ4220/ 968999692, EZ4824 / 968999696 EZ5224 / 968999699, EZ4824C / 968999754 EZ5224 BF / 968999766 Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. English ©2008 HTC All Rights Reserved. Printed in U. S. A. CONTENTS INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 General. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 . Driving and Transport on Public Roads. . . . . . . . . . . . . . . . . 5 Towing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Operating. [. . . ] Recharge at 6-10 amperes for 1 hour. Always use protective glasses when handling the battery. IMPORTANT INFORMATION Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary. Always use two wrenches for the terminal screws Cleaning Battery and Terminals Corrosion and dirt on the battery and terminals can cause the battery to “leak” power. 2. Disconnect BLACK battery cable first, then the RED battery cable and remove the battery from the machine. 3. Rinse the battery with plain water and dry. 4. Clean terminals and battery cable ends with wire brush until shiny. 5. Coat terminals with grease or petroleum jelly 6. Reinstall battery. WARNING!Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparks from accidental grounding. Replacing Battery 1. Lift seat and rotate forward. 3. Using two ½" wrenches disconnect BLACK battery cable then RED battery cable. 4. Using 7/16" wrench, remove terminal guard. 5. Carefully remove the battery from the mower. 6. Install new battery with terminals in the same position as the old battery. 8. First connect RED battery cable to positive (+) battery terminal with hex bolt and hex nut. 9. Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and hex nut. 12. Lower seat. 2 1 CZ-22 1. Terminal access doors Battery installation English-39 MAINTENANCE The engine is equipped with an electronic ignition system. Only the spark plugs require maintenance. For recommended spark plugs, see Technical Data. 1. Remove the ignition cable boot and clean around the spark plug. 2. Remove the spark plug with a spark plug socket wrench. [. . . ] Lifetime Warranty (“PARTS ONLY” after initial warranty expiration): Ignition coils and modules on handheld product. Proof of purchase required. SECTION 2: HUSQVARNA S OBLIGATIONS UNDER THE WARRANTY SECTION 3: ITEMS NOT COVERED BY THIS WARRANTY The following items are not covered by this warranty: Husqvarna will repair or replace defective components without charge for parts or labor if a component fails because of a defect in material or workmanship during the warranty period. (1) Normal customer maintenance items which become worn through normal regular use, including, but not limited to, belts, blades, blade adapters, bulbs, clutches, clutch drums, filters (fuel line, fuel filters, air filters, oil filters), sprockets, guide bars, lubricants, rewind springs, saw chain, spark plugs, starter ropes and tiller tines; (2) Natural discoloration of material due to ultraviolet light; (3) Engine and drive systems not manufactured by Husqvarna; these items are covered by the respective manufacturer s warranty as provided in writing with the product information supplied at the time of purchase; all claims must be sent to the appropriate manufacturer. (4) Lawn and garden attachments that are covered by a third party which gives a warranty, all claims for warranty should be sent to the manufacturer. (5) Commercial or consumer mowing decks with sand abrasion damage. [. . . ]