User manual HUSQVARNA EZC 4824

[. . . ] EZC4824 / 966038501 EZ4824 / 965880401 Operator Manual Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. EZ4824K / 966038201 EZ5224 / 966038301 EZ6124 / 966038401 In order to implement improvements, specifications and designs can be altered without prior notification. Note that no legal demands can be placed based on the information contained in these instructions. The use of other parts voids the warranty. Do not modify or install non-standard equipment to the unit without consent from the manufacturer. [. . . ] When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine. 2. Move the steering controls to the neutral position (N). Parking brake released 8058-020 3. Set retaining pin into selected cutting height and secure the opposite side with a cotter hairpin. WARNING!Ensure that no one is near mower when engaging blade switch. Make sure the work area is free from objects that could be thrown by the rotating blades. Secure selected cutting height 8058-024 4. Push the release button on the cutting height lever and move lever to the pin, release the button. 5. Set the cutting height with the cutting height adjustment lever. Mower deck lifting lever 8058-019 Husqvarna-29 operation 6. Engage the mower deck by pulling out the blade switch. 7. Move throttle control to full throttle. The machine’s speed and direction are continuously variable using the two steering controls. When both controls are in the neutral position, the machine stands still. By moving both controls an equal amount forward or backward, the machine moves in a straight line forward or backward respectively. In order, for example, to turn right while moving forward, move the right control towards the neutral position. The rotation of the right wheel is reduced and the machine turns to the right. Turning on the spot (zero turn) can be achieved by moving one control backward (behind the neutral position) and carefully moving the other steering control forward from its neutral position. ST FA CHOKE UP BLADES ON DOWN BLADES OFF OW SL Set blade engagement and throttle control 8052-001 Operating On Hills Read the Safety Instructions “Driving on Slopes” in the “Safety Instructions”. Do not drive up or down hills with slopes greater than 10 degrees. Do not drive across slopes. • • • The slowest speed possible should be used before starting up or down hills. Avoid stopping or changing speed on hills. If stopping is absolutely necessary, pull drive levers into the neutral position and push to the outside of the unit and engage the parking brake. Place controls in neutral position 8061-026 IMPORTANT INFORMATION Control levers return to neutral when released. This may cause the mower to suddenly stop. • • • To restart movement, release the parking brake. Pull the control levers back to the center of the mower and press forward to regain forward motion. Make all turns slowly. Parking brake released 30-Husqvarna 8058-020 operation Mowing Tips • • Observe and flag rocks and other fixed objects to avoid collisions. Begin with a high cutting height and reduce it until the desired mowing result is attained. The average lawn should be cut to 2½" (64 mm) during the cool season and over 3" (76 mm) during the hot months. [. . . ] ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THESE PRODUCTS IS LIMITED IN DURATION TO THE WARRANTY PERIOD AS DEFINED IN THE LIMITED WARRANTY STATEMENT. HUSQVARNA RESERVES THE RIGHT TO CHANGE OR IMPROVE THE DESIGN OF THE PRODUCT WITHOUT NOTICE, AND DOES NOT ASSUME OBLIGATION TO UPDATE PREVIOUSLY MANUFACTURED PRODUCTS. Some states do not allow the exclusion of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary by state. [. . . ]