User manual HUSQVARNA FS 305

[. . . ] Utilisation : sawing with sprinkling of fresh, old or coated (asphalt) concrete. These signs give advice concerning your safety DO DO carefully read and understand all the instructions before operating the saw. DO aways wear safety approved hearing, eye, head and respiratory protection. [. . . ] Any persons not involved in the work should leave the working area Use only blades marked with a maximum operating speed greater than blade shaft speed Firmly tighten the screw (D) with the spanner provided with the machine, holding the disc steady by hand. Replace the protective guard (if this is not replaced the casing safety switch will prevent the saw being started). Turn the handwheel (K) to free the disk from the groove [SEE FIG. No need to lock the saw up by releasing the handwheel (K). Emergency stop Operate the switch (J) in front of the engine. 9 7 Starting up Always pay extreme care and attention to the preparation of the machine before starting up Remove all adjustment tools and wrenches from floor and machine Always keep blade guard in place · Turn off the water tap (G) (from the mains or from the tank in order to fill it) [SEE There may be several causes responsible for arresting the disc in the sawing groove or stopping the machine: s Belt tension. In all case, disengage the disc from the groove and give the machine a complete check-over. Take into account the working conditions from health and safety point of wiew. S Check the oil level; as the motor often Works at an angle, check it frequently in the horizontal position that the oil level is never below the second line on the gauge. Mark out a line on the ground where a cut has to be made. Position the machine so that the lowered front guide (F) and the disc are aligned with the line marked out (disc visble on the belt side of the housing). 10 Maintenance (with the engine stopped) "Engine Maintenance" : refer to the engine maintenance booklet. Unscrew the nuts (E) from the guard housing [SEE FIG. Note the direction of rotation indicated by an arrow on one side of the disc (direction of rotation shown on the outside of the guard housing). Hold the saw, turn the handwheel (K) and position the disk in contact with the floor. Lower to the depth of cut required, and bearing in mind that each graduation of the scale corresponds to a depth of 1cm. Lower slowly to prevent the engine stalling. Gently move the machine forward ensuring that the front guide and the disc are always aligned with the line marked out. [. . . ] The manufacturer is not responsible for any direct or indirect, material or immaterial, damages caused to persons or things by failure of the machine or the non operation of the machine. WARRANTY CONDITIONS To benefit the warranty, it is necessary to return the joined warranty certificate, duly completed, to Husqvarna within eight days of the purchase. In case of failure of the machine during the warranty period, our after-sales services will inform you of the appropriate and most effective method of dealing with your claim and advise you if necessary of your nearest approved service centre. [. . . ]