User manual HUSQVARNA GTH 2250 C

[. . . ] GTH2250 Owner’s Manual SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. I. GENERAL OPERATION • • • • • • • • • • • • • • • • Read, understand, and follow all instructions in the manual and on the machine before starting. Only allow responsible adults, who are familiar with the instructions, to operate the machine. [. . . ] Adding or checking level of electrolyte is not necessary. IMPORTANT: TO ENSURE PROPER ASSEMBLY, CENTER HOLE IN BLADE MUST ALIGN WITH STAR ON MANDREL ASSEMBLY. • • Reassemble hex bolt, lock washer and flat washer in exact order as shown. torque). IMPORTANT: BLADE BOLT IS GRADE 8 HEAT TREATED. 17 CUSTOMER RESPONSIBILITIES TO CLEAN BATTERY AND TERMINALS Corrosion and dirt on the battery and terminals can cause the battery to “leak” power. • Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor. • Rinse the battery with plain water and dry. • Clean terminals and battery cable ends with wire brush until bright. • Coat terminals with grease or petroleum jelly. • Reinstall battery (See “REPLACING BATTERY" in the SERVICE AND ADJUSTMENTS section of this manual). Check the crankcase oil level before starting the engine and after each eight (8) hours of operation. Tighten oil fill cap/ dipstick securely each time you check the oil level. 15) Determine temperature range expected before oil change. All oil must meet API service classification SF-SJ. • Be sure tractor is on level surface. • Oil will drain more freely when warm. • Catch oil in a suitable container. Be careful not to allow dirt to enter the engine when changing oil. • Remove yellow cap from bottom fitting of drain valve and install the drain tube onto the fitting. OIL DRAIN VALVE V-BELTS Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. Replace belts if they begin to slip from wear. TRANSAXLE COOLING The transmission fan and cooling fins should be kept clean to assure proper cooling. Do not attempt to clean fan or transmission while engine is running or while the transmission is hot. To prevent possible damage to seals, do not use high pressure water or steam to clean transaxle. • Inspect cooling fan to be sure fan blades are intact and clean. • Inspect cooling fins for dirt, grass clippings and other materials. To prevent damage to seals, do not use compressed air or high pressure sprayer to clean cooling fins. YELLOW CAP DRAIN TUBE CLOSED AND LOCKED POSITION FIG. [. . . ] Roller, Nose Bolt, Carriage 3/8-16 x 1-3/4 Gr. Pin Head Rivot Bracket Ga Wh Asm RH 50 Bracket Ga Wh Asm LH 50 Bracket Ga Wh Assy F RH 50 Bracket Ga Wh Assy F LH 50 Bolt Carraige 5/16- 18 x 5/8 Nut Crownlock 5/16-18 Washer 17/32 x 3/4 x 16 Ga. Bolt Carriage 5/16-Unc 1/2 Reinforcement Mandrel Ring Mandrel Asm (Includes Key Nos. 810, 13-15, 31 and 33) Replacement Mower, Complete NOTE: All component dimensions given in U. S. [. . . ]