User manual HUSQVARNA HECTH200B

[. . . ] 14 STARTING AND STOPPING Check before starting . 18 Adjusting the edger’s cutting depth 19 Maintenance schedule . 21 EMISSION CONTROL WARRANTY STATEMENT . 22 The Emissions Compliance Period referred to on the Emissions Compliance label indicates the number of operating hours for which the engine has been shown to meet Federal emissions requirements. [. . . ] Children, animals, onlookers and helpers should be outside the safety zone of 15 meters (50 feet). Stop the machine immediately if anyone approaches. The bevel gear unit can get hot during use and may remain so for a while afterwards. There is a risk of slight burns if you touch it. S Always ensure you have a safe and firm foothold. S Always hold the machine with both hands. Hold the machine of the right-hand side your the body. S Make sure your hands and feet do not come into contact with the blade when the engine is running. S When the engine is switched off, keep your hands and feet away from the blade until it has stopped. S Always keep the blade close to the ground. 10 SAFETY INSTRUCTIONS Safety instructions after completing work S Ensure the blade has stopped before cleaning, making repairs or an inspection. Remove the spark plug cable from the spark plug. S Wear heavy-duty gloves when making repairs to the edger. S The lowest recommended octane rating is 87. If you run the engine on lower octane rating than 87, “knocking” can occur. This leads to an increased engine temperature, which can result in a serious engine breakdown. S When working at continuous high revs a higher octane rating is recommended. S Do not mix more than one month’s supply of fuel at a time. S If the machine is not used for some time, the fuel tank should be emptied and cleaned. WARNING: The catalytic converter muffler gets very hot during and after use. Be aware of the fire hazard, especially when working near flammable substances and/or vapors. Fueling WARNING: Two-stroke oil S For great results and performance use HUSQVARNA two-stroke oil, which is specially formulated for our two-stroke engines. S To maximize the life of your trimmer, you may choose to use a high quality synthetic oil formulated for two-stroke engines. S Never use two-stroke oil intended for water-cooled outboard engines, sometimes referred to as outboard oil. S Never use oil intended for four-stroke engines. gallon 1 2 1/2 5 Two- stroke oil 2% (1:50) U. S. [. . . ] Should an operational problem or failure occur, the product should not be used, but delivered as is to an authorized Husqvarna dealer for evaluation. Proof of purchase, as explained in Section 6, rests solely with the customer. SECTION 4: EXCEPTIONS AND LIMITATIONS This warranty shall be inapplicable to defects resulting from the following: (1) Accident, abuse, misuse, negligence and neglect, including stale fuel, dirt, abrasives, moisture, rust, corrosion, or any adverse reaction due to incorrect storage or use habits. (2) Failure to operate or maintain the unit in accordance with the operator’s manual or instruction sheet furnished by Husqvarna. (3) Alterations or modifications that change the intended use of the product or affects the product’s performance, operation, safety, or durability, or causes the product to fail to comply with any applicable laws. [. . . ]