User manual HUSQVARNA HEDGE TRIMMER ATTACHMENT

[. . . ] Please read these instructions carefully and make sure you understand them before using the machine. Careless or incorrect use can result in serious, even fatal injury. Read through the Operator`s Manual carefully and understand the content before using the hedge trimmer. Other symbols/decals on the machine refer to special certification requirements for certain markets. [. . . ] â· Never allow anyone to use the machine without first being absolutely sure that they understand the contents of the Operator's Manual. â· Never work on a ladder, stool or any other raised position that is not fully secured. Always lay the hedge trimmer on the ground when you are not using it. â· Check the hedge you intend to trim for foreign objects such as electricity cables, insects and animals, etc, and for other objects that could damage the cutting attachment, such as metal items. If anything jams in the blades while you are working, switch off the engine and wait until it has stopped completely before cleaning the blades. The transport guard should always be fitted to the blades when the machine is not in use. â· Ensure the blades have stopped and remove the spark plug cable from the spark plug before carrying out cleaning, repairs or an inspection. â· Always wear heavy duty gloves when repairing the blades. The blades are extremely sharp and can easily causes cuts. â· Store the machine out of reach from children. â· Only use original spare parts when carrying out repairs. Do not hold the cutting attachment when you adjust the angle. The blades are sharp and you could easily cut yourself. Press the cutting attachment against the ground or some other solid object to set the desired angle. Work with a swinging action from the bottom upwards when trimming sides. When trimming a hedge the engine should always be turned away from the hedge. â· The hedge trimmer should be held as close to the body as possible to get the best balance. â· Make sure that the tip does not touch the ground. â· Do not try to force the work, but move at a steady speed so that all the stems are cut evenly. What is what on the hedge trimmer attachment?Hand guard fastening screw Angle adjuster knob Hand guard Operator's manual Transport guard Shaft coupling Assemble the hand guard and loop handle by screwing them together. Take care to align the holes in both parts. [. . . ] Adjusting the carburettor while a dirty airfilter is in use will result in a leaner mixture when the filter is finally cleaned. This can give rise to serious engine damage. â· Carefully turn the L and H needle to the mid point between fully turned in and fully turned out. â· Do not attempt to adjust the needles beyond the stops as damage can occur. [. . . ]