User manual HUSQVARNA HELT125F

[. . . ] Use extension cords and receptacles as specified by the manufacturer for all units with electric drive motors or electric starting motors. Never attempt to make any adjustments while the engine (motor) is running (except when specifically recommended by manufacturer). Always wear safety glasses or eye shields during operation or while performing an adjustment or repair to protect eyes from foreign objects that may be thrown from the machine. Let engine and machine adjust to outdoor temperatures before starting to clear snow. [. . . ] NOTE: For best results, purchase only the quantity of gasoline that you expect to use in 30 days. Otherwise, you may add fuel stabilizer to newly purchased gasoline to keep it fresh for up to 6 months. Move the snowthrower to a level surface. NOTE: Dipstick location may vary depending on engine type. Remove either side mounted filler cap dipstick or high oil fill dipstick (1) and wipe it clean. Insert the dipstick into the filler neck and turn clockwise until fully seated. Then remove the dipstick by turning it counter-clockwise. Fill oil to "FULL" on dipstick with the recommended oil. Securely screw in the oil filler cap/dipstick. NOTE: Running the engine with a low oil level can cause engine damage. Always check the engine oil before start up. To disengage the auger blades, release the control bar (1). IMPORTANT: During initial operation there may be wear between the auger blades and the scraper bar. Maximum performance, both snow throwing and driving, occurs when there is zero clearance between these two parts (2, 3). During initial break-in period of the auger blades it is normal for the auger blades to build up excessive heat if not operated in the snow. Do not operate without snow or water for lubricating the auger blades. This will cause excessive heat build up in the auger blades which could cause damage to the auger blades and scraper bar. To adjust the discharge chute, rotate chute handle (1) left or right to desired position. To raise or lower the angle of the chute deflector (2), loosen both chute deflector knobs (3) on the chute deflector and move the chute deflector up or down to desired position and retighten knobs. 30 Clearing a Clogged Discharge Chute Hand contact with the rotating auger blades inside the discharge chute is the most common cause of injury associated with snow throwers. Never use your hand to clean out the discharge chute. Wait 10 seconds to be sure the auger blades have stopped rotating. [. . . ] (See “Changing the Engine Oil” section of this manual). Pour one ounce (29 ml) of oil through spark plug hole into cylinder. Pull recoil starter handle slowly a few times to distribute oil. OTHER • • • Remove safety key; store it in a safe place. [. . . ]