User manual HUSQVARNA HEYTH135B

[. . . ] Local regulations may restrict the age of the operator. â· Never mow while people, especially children, or pets are nearby. â· Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. Such instruction should emphasize: - the need for care and concentration when working with ride-on machines; - control of a ride-on machine sliding on a slope will not be regained by the application of the brake. [. . . ] â· Adjust gauge wheels with tractor on a flat level surface. With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. The throttle control regulates the engine revs and thus the rotation speed of the blades. = Full speed = Idling speed When the pedal is pushed down the brake is applied and the motor is disengaged. There are four different positions for this lever: N = Neutral (no drive) S = Slow F = Fast R = Reverse The lever can be moved steplessly between S and F to ensure the required speed. Move the lever forward to connect the drive to the cutting unit, whereby the drive belt is tensioned and the blades begin to rotate. If the lever is moved backwards the drive will be disconnected and the rotation of the blades slowed down by the action of the brake shoes on the pulley. Quick lifting/lowering of the cutting unit Pull the lever backwards to quickly lift the cutting unit when passing over irregularities in the lawn, etc. During transportation the cutting unit shall be in the highest position. to lower the unit: Pull the lever backward (1). Push in the button (2) and then move the lever forward (3). Make sure that the cutting unit is in the transport position (top position) and that the lever for connection/disconnection of the cutting unit is in the disconnection position. Press down the clutch/brake pedal completely and hold down. Pull out the choke control (if engine is cold). Turn the ignition key to "START position". Do not run the start motor more than 5 seconds at once. If the engine will not start, wait about 10 seconds before the next try. Let the ignition key return to the "ON" position when the engine has started and push in the choke control as soon as the engine is running smoothly. To ensure proper operation and performance, it is recommended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have developed during shipping of your tractor. Park tractor on level surface so it will not roll in any direction. Parking brake must be disengaged for the following procedure. [. . . ] Distance "A" should be the same or within 6mm (1/4") of each other. â· If adjustment is necessary, make adjustment on one side of mower only. NOTE: Three full turns of adjustment nut will change mower height about 1/8". Dismantle the cutting unit as described previously Engage the parking brake and work off the belt upwards from the pulley (1), the clutch pulley (2) and the engine's drive wheel (3). [. . . ]