User manual HUSQVARNA HFCRT81

[. . . ] Switch off the engine before carrying out any checks or maintenance. The start/stop switch automatically returns to run position. In order to prevent unintentional starting, the spark plug cap must be removed from the spark plug when assembling, checking and/or performing maintenance. Always wear approved protective gloves. Regular cleaning is required. Never operate a chain saw holding it with one hand only. Visual check. Contact of the guide bar tip with any object must be avoided. [. . . ] As the chain brake is still engaged the speed of the engine must be set to idling as soon as possible, this is achieved by disengaging the throttle lock. Disengagement is done by gently touching on the throttle trigger. This prevents unnecessary wear to the clutch, clutch drum and brake band. Allow the machine to idle a few seconds before giving full throttle. There is a simplified start reminder with illustrations to describe each step on the rear edge of the saw (A). Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. Pull the front hand guard towards the front handle. Your saw is ready for use. ! • WARNING!Long term inhalation of the engine’s exhaust fumes, chain oil mist and dust from sawdust can represent a health risk. Never start a chain saw unless the bar, chain and all covers are fitted correctly. See instructions under the heading Assembly. Without a bar and chain attached to the chain saw the clutch can come loose and cause serious injury. When you put the chain saw on the ground, lock the saw chain using the chain brake and ensure you have a constant view of the machine. Switch the engine off before leaving your chain saw for any length of time. 5 4 3 Take great care when removing small branches and avoid cutting bushes (i. e. cutting many small branches at the same time). Small branches can be grabbed by the chain and thrown back at you, causing serious injury. Make sure you can move and stand safely. Check the area around you for possible obstacles (roots, rocks, branches, ditches, etc. ) in case you have to move suddenly. Take great care when working on sloping ground. Take great care when cutting a tree that is under tension. A tree that is under tension may spring back to its normal position before or after being cut. If you position yourself incorrectly or make the cut in the wrong place the tree may hit you or the machine and cause you to lose control. [. . . ] Keep a good firm grip on the saw with both hands, the right hand on the rear handle, and the left hand on the front handle, when the engine is running. Use a firm grip with thumbs and fingers encircling the chain saw handles. A firm grip will help you reduce kickback and maintain control of the saw. Make sure that the area in which you are cutting is free from obstacles. [. . . ]