User manual HUSQVARNA HFYTH170E

[. . . ] Local regulations may restrict the age of the operator. â· Never mow while people, especially children, or pets are nearby. â· Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. Such instruction should emphasize: - the need for care and concentration when working with ride-on machines; - control of a ride-on machine sliding on a slope will not be regained by the application of the brake. [. . . ] Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions. â· Adjust gauge wheels with tractor on a flat level surface. With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. The accelerator control regulates the motor speed and also the speed of the blades. Full speed lies between these two positions. When the pedal is pushed down the brake is applied and the motor is disengaged. There are four different positions for this lever: N = Neutral (no drive) S = Slow F = Fast R = Reverse The lever can be moved steplessly between S and F to ensure the required speed. Quick lifting/lowering of the cutting unit Pull the lever backwards to quickly lift the cutting unit when passing over irregularities in the lawn, etc. During transportation the cutting unit shall be in the highest position. to lower the unit: Pull the lever backward (1). Press down the clutch/brake pedal completely and hold down. Turn the ignition key to "START position". Do not run the start motor more than 5 seconds at once. If the engine will not start, wait about 10 seconds before the next try. Let the ignition key return to the "ON" position when the engine has started Push the gas control to the required speed. Start engine and move throttle control to slow position. Move motion control lever to full forward position and hold for five (5) seconds. Move lever to full reverse position and hold for five (5) seconds. move motion control lever to neutral (N) position. Stop tractor by turning ignition key to "OFF" position. engage transmission by placing freewheel control in driving position. [. . . ] To open valve, push in slightly, turn counterclockwise and pull out. â· To close valve, push in and turn clockwise. Fill in dates as you complete regular service As Needed Every 8 hours Every 25 hours Every 50 hours Every 100 hours Every 200 hours For best results mower blades must be kept sharp. Sharpening can be carried out with a file or grinding disc. [. . . ]