User manual HUSQVARNA HUS625HWT

[. . . ] Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not worn or damaged. replace worn or damaged blades and bolts in sets to preserve balance. On multi-bladed machines, take care as rotating one blade can cause other blades to rotate. Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. [. . . ] Never pick up or carry lawnmower while the engine is running. Stop the engine and disconnect the spark plug wire: - before cleaning blockages or unclogging chute; - before checking, cleaning or working on the lawnmower; - after striking a foreign object. Inspect the lawnmower for damage and make repairs before restarting and operating the lawnmower; - if the lawnmower starts to vibrate abnormally (check immediately). Stop the engine: - whenever you leave the lawnmower; - before refuelling. Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off valve, turn the fuel off at the conclusion of mowing. Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. Never store the equipment with petrol in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure. To reduce the fire hazard, keep the engine, silencer, battery compartment and petrol storage area free of grass, leaves, or excessive grease. If the fuel tank has to be drained, this should be done outdoors. These symbols may appear on your machine or in the literature supplied with the product. NOTE: The foot guard must be installed for the safe operation of this machine. Position guard as shown and secure with fasteners supplied. NOTE: The foot guard must be installed for the safe operation of this machine. Put grass catcher frame into grass bag with stiff part of bag on the bottom. The grass catcher is secured to the lawn mower housing when the rear door is lowered onto the grass catcher frame. Do not drag the bag when emptying, it will cause unnecessary wear. There are four (4) available heights of cut on your lawn mower. The mower can be set to different cutting levels. Adjust to desired cutting level by means of the lever at each wheel. Move the lever towards the wheel and set the cutting level. Fill the tank with petrol, not oil-blended. [. . . ] examine the result and lower the mower to the desired setting. Mow slowly or mow the grass twice if it is very long. Always remove the spark plug lead before repair, cleaning or maintenance work. After 5 hours running time, tighten screws and nuts. [. . . ]