User manual HUSQVARNA J-HANDLE KIT 125 L

[. . . ] Under no circumstances may the design of the machine be modified without the permission of the manufacturer. Non-authorized modifications and/or accessories can result in serious personal injury or the death of the operator or others. This accessory may only be used together with the intended trimmer, see under heading "Approved accessories" in chapter Technical data in the machine's Operator's Manual. Only grass blades/grass cutters or trimmer heads/plastic blades may be used when the J-handle is fitted. [. . . ] Sometimes branches or grass get caught between the guard and cutting attachment. Grass blades and grass cutters must not be used on woody stems. A grass blade is used for all types of tall or coarse grass. The grass is cut down with a sideways, swinging movement, where the movement from right-to-left is the clearing stroke and the movement from left-to-right is the return stroke. If the blade is angled to the left when clearing grass, the grass will collect in a line, which makes it easier to collect, e. Move forward after the return stroke and stand firmly again. Let the support cup rest lightly against the ground. It is used to protect the blade from hitting the ground. Reduce the risk of material wrapping around the blade by following these instructions: 1 2 Always work at full throttle. Avoid the previously cut material during the return stroke. Stop the engine, unclip the harness and place the machine on the ground before you start to collect the cut material. Neither the operator of the machine nor anyone else may attempt to remove the cut material while the engine is running or the cutting equipment is rotating, as this can result in serious injury. Stop the engine and cutting equipment before you remove material that has wound around the blade shaft as otherwise there is a risk of injury. Can be thrown up into the eyes causing blindness or serious injury. keep unauthorised persons at a distance. Children, animals, onlookers and helpers should be kept outside the safety zone of 15 m. Stop the machine immediately if anyone approaches. Only grass blades/grass cutters or trimmer heads/plastic blades may be used when the J-handle is fitted. Saw blades must never be used with the J-handle. Note that the loop handle must be fitted between the arrows on the shaft. Attach the J-handle to the loop handle using the two screws, as shown. Place the blade (D), support cup (E) and support flange (F) on the output shaft. [. . . ] Centre hole in blades/cutters, Ø 25, 4 mm Terms Grass blade/ grass cutter Trimmer head Plastic blades Support cup Type Grass 255-4 1" (Ø 255 4-teeth) T25 Tricut Ø 300 mm Fixed Cutting attachment guard, Art. Check that the support flange is not cracked due to fatigue or due to being tightened too much. Ensure the locking nut has not lost its captive force. The nut lock should have a locking force of at least 1. [. . . ]