User manual HUSQVARNA K3000 WET

[. . . ] Operator′s manual K3000 K3000 Wet Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. English KEY TO SYMBOLS Symbols on the machine: WARNING!The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Always wear: • • • Approved protective helmet Approved hearing protection Protective goggles or a visor Visual check. [. . . ] Make sure that no pipes or electrical cables are routed in the working area or in the material to be cut. Always check and mark out where gas pipes are routed. Cutting close to gas pipes always entails danger. Make sure that sparks are not caused when cutting in view of the risk of explosion. Remain concentrated and focused on the task. Carelessness can result in serious personal injury or death. The guard for the cutting equipment must always be on when the machine is running. • • • • • • • • • • • • • • • • ! WARNING!Overexposure to vibration can lead to circulatory damage or nerve damage in people who have impaired circulation. Contact your doctor if you experience symptoms of overexposure to vibration. These symptoms include numbness, loss of feeling, tingling, pricking, pain, loss of strength, changes in skin colour or condition. These symptoms normally appear in the fingers, hands or wrists. • Service • Have your power tool serviced by a qualified repair person unsing only identical replacement parts. This will ensure that the safety of the power tool is maintained. 10 – English SAFETY INSTRUCTIONS Cutting blades Special blades Some cutting blades are designed for stationary equipment and for use with attachments. Such cutting blades must not be used on portable power cutters. Always contact local authorities and make sure you are following applicable directives. Blade vibration The blade can become out-of-round and vibrate if an excessive feed pressure is used. A lower feed pressure can stop the vibration. The blade must be of the recommended type for the material to be cut. ! WARNING!A cutting blade may burst and cause injury to the operator. Never use a cutting blade at a lower speed rating than that of the power cutter. Never use a cutting blade for any other materials than that it was intended for. General • Cutting blades are available in two basic designs; abrasive baldes and diamond blades. Abrasive blades The cutting material on abrasive blades consists of grit bonded using an organic binder. ”Reinforced blades” are made up of a fabric or fibre base that prevents total breakage at maximum working speed if the blade should be cracked or damaged. A cutting blade’s performance is determined by the type and size of abrasive corn, and the type and hardness of the bonding agent. Check that the blade is approved for the same or higher speed according to the aproval plate of the engine. [. . . ] Use high quality gear grease The gear housing must not be filled completely with grease. The grease expands as the machine heats up during operation. If the gear housing was completely filled with grease it could damage the seals and lead to leakage of grease. The gear housing should contain 90 g of grease in total. Checking the drive shaft and flange washers Check that the threads on the drive shaft are undamaged. [. . . ]