User manual HUSQVARNA LRH125

[. . . ] Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Always wear: • • • A protective helmet where there is a risk of falling objects Approved hearing protection Approved eye protection Other symbols/decals on the machine refer to special certification requirements for certain markets. Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance. Wear sturdy, non-slip boots. Only use non-metallic, flexible cutting attachments, i. e. [. . . ] The blade should be angled forward a little. 2 Grass clearing The support hook should hang around 20 cm below your hip so that the blade is parallel to the ground. Correct balance 1 Forestry clearing Move the suspension ring on the machine forward or backward. It is easier to avoid sawing into the ground if the blade is balanced a few dm above the ground. 2 Grass clearing Let the blade balance at a comfortable cutting height, i. e. close to the ground. English – 17 FUEL HANDLING Fuel safety Never start the machine: 1 2 If you have spilt fuel on it. Wipe off the spillage and allow remaining fuel to evaporate. If you have spilt fuel on yourself or your clothes, change your clothes. Wash any part of your body that has come in contact with fuel. Check regularly for leaks from the fuel cap and fuel lines. Petrol 3 CAUTION!Always use a quality petrol/oil mixture at least 90 octane (RON). If your machine is equipped with a catalytic converter (see chapter on Technical data) always use a good quality unleaded petrol/oil mixture. For this reason observe caution when handling fuel and make sure there is adequate ventilation. 18 – English FUEL HANDLING Mixing • • Always mix the petrol and oil in a clean container intended for fuel. Always start by filling half the amount of the petrol to be used. Mix (shake) the fuel mixture thoroughly before filling the machine’s fuel tank. Fuelling ! WARNING!Taking the following precautions, will lessen the risk of fire: Do not smoke or place hot objects near fuel. Always shut off the engine before refuelling. Always stop the engine and let it cool for a few minutes before refuelling. When refuelling, open the fuel cap slowly so that any excess pressure is released gently. Tighten the fuel cap carefully after refuelling. Always move the machine away from the refuelling area before starting. • • • Do not mix more than one month’s supply of fuel at a time. If the machine is not used for some time the fuel tank should be emptied and cleaned. • • • Always use a fuel container with an anti-spill valve. Contamination in the tank can cause operating problems. [. . . ] Check that there are no fuel leaks from the engine, tank or fuel lines. Check that the transport guard for the blade is intact and that it can be secured correctly. Check that the vibration damping elements are not damaged. Adjust the gap to 0. 5 mm or replace the spark plug. [. . . ]