User manual HUSQVARNA LTH174

[. . . ] Instruction manual Please read these instructions carefully and make sure you understand them before using this machine. Prezechowywanie Uskladnenie Tárolás 3 18 23 31 33 43 74 77 We reserve the right to make changes without prior notice. Safety Rules Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. Be familiar with the controls and the proper use of the equipment. [. . . ] Total time taken is not greater, since higher drive speed can be selected without affecting the cutting results. The cutting results will be worse since the wheels will sink into the soft lawn. Spray the cutting unit with water underneath after use. € • • Do not drive in terrain at an angle of more than max. The risk for roll-over backwards is large. In steep terrain the risk for tipping is considerable. € • Drive in right turns so that the cut grass is thrown away from flower beds and paths, etc. For larger lawns the drive direction should be changed after 2-3 turns so that the cut grass is thrown towards the area that has already been cut as shown in the illustration. Use the left side of the machine to cut close to trees, bushes and paths, etc. The blade cuts about 15 mm inside the edge of the cover. 41 5 Switching off the engine Move the attachment clutch control to disengaged position. Move the throttle control between half and full speed (fast) position. Lift up the cutting unit and turn the ignition key to “STOP” position. Do not leave the ignition key in the machine when not in use to prevent children and other unauthorized persons starting the engine. Before servicing the engine or cutting unit the following shall be carried out: • Press down the clutch/brake pedal and engage the parking brake lever. € Remove the ignition cable from the plug. Grasp hood at sides, tilt forward and lift off of tractor. Maintenance NOTE: Periodic maintenance should be performed on a regular basis in order to keep your tractor in good running condition. WARNING: Disconnect spark plug wire to prevent accidental starting before attempting any repair, inspection, or maintenance. Before each use: • Check oil, lubricate pivot points as necessary. € Check to see all bolts, nuts, and cotter pins are in place and secure. € Keep tractor free of dirt and chaff to prevent engine damage or overheating. [. . . ] € Pull back the lock collar of the nozzle adapter to disconnect the adapter from the nozzle washout port. € Move the tractor to a dry area, preferably a concrete or paved area. Place the attachment clutch control in the “Engaged” position to remove excess water and to help dry before putting the tractor away. WARNING: A broken or missing washout fitting could expose you or others to thrown objects from contact with the blade. [. . . ]