User manual HUSQVARNA MASTER50S

[. . . ] Manual lawn mower Assemble the handle and fit the brake lever with the pin and clip provided, assemble wheels as shown and throttle if supplied. Self-Propelled Assemble the handle and fit the levers with pins and clips provided, assemble wheels as shown and throttle if required. L Never place your hands or feet underneath the deck or into the rear grass discharge chute while the engine is running. Before mowing, remove all foreign objects from the lawn which may be thrown by the machine. [. . . ] Never use the mower for other purposes (e. , for flattening out bumps in the ground, such as mole-hills or ant- hills). D)Work only when there is sufficient light. E)Before mowing, remove all foreign objects from the lawn which may be thrown by the machine. While mowing, stay alert for any foreign objects which may have been missed. lStore fuel in containers specifically designed for this purpose. L Refuel outdoors only and do not smoke while refuelling. l Fill up the fuel tank before starting the engine. Under no circumstances open the fuel tank cap or add petrol when the engine is running or when it is still hot. L If the petrol has overflowed, do not under any circumstances start up the engine. Move the mower away from the area where fuel has bean spilt and avoid any source of possible ignition until the petrol fumes have dissipated. l Replace the fuel tank cap and tighten it down firmly. E)Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. F) When mowing, never run; you must always walk. G)Exercise extreme caution when turning or when pulling the lawn mower towards you. H)Particular precautions must be taken when mowing on slopes or downhill stretches: lUse appropriate antislip footwear. L Mow across the face of slopes, never up or down. L Take great care when changing direction. lDo not mow on excessively steep slopes. I)Never use the lawn mower unless the guards and safety devices (e. [. . . ] LNever clean the mower by pouring water over it: this may seriously damage the electric start system. LTake care, the exhaust muffler may be very hot. LFrequently remove the wheel screws clean whith petroleum and oil before replacing. Ball bearings must be greased before remounting. [. . . ]