User manual HUSQVARNA MZ ZTR

[. . . ] MZ5225 / 968999717 MZ7227 / 968999719 MZ6125BF / 968999721 MZ6125C / 968999749 Operator's Manual MZ6125 / 968999718 MZ5225BF / 968999720 MZ5225C / 968999748 MZ25 / 968999780 Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. English ©2008 HTC. Printed in U. S. A. Contents INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Driving and Transport on Public Roads. . . . . . . . . . . . . . . . . . . . . . . [. . . ] The rotation of Engage the mower deck and move throttle to full. 8061-002 English-31 operation the right wheel is reduced and the machine turns to the right. Turning on the spot (zero turn) can be achieved by moving one control backward (behind the neutral position) and carefully moving the other steering control forward from its neutral position. Operating on hills Read the Safety Instructions “Driving on Slopes” in the “Safety Instructions”. WARNING!Do not drive up or down hills with slopes greater than 10 degrees. Do not drive across slopes. • The slowest speed possible should be used before starting up or down hills. • Avoid stopping or changing speed on hills. • If stopping is absolutely necessary, pull drive levers into the neutral position and push to the outside of the unit and engage the parking brake. IMPORTANT INFORMATION When in reverse, control levers return to neutral when released. This may cause the mower to suddenly stop. • To restart movement, release the parking brake. • Pull the control levers back to the center of the mower and press forward to regain forward motion. • Make all turns slowly. Place controls in neutral position 8061-012b Released parking brake 8061-010 English-32 operation Mowing Tips • Observe and flag rocks and other fixed objects to avoid collisions. • Begin with a high cutting height and reduce it until the desired mowing result is attained. The average lawn should be cut to 2½" (64 mm) during the cool season and over 3" (76 mm) during the hot months. For healthier and better looking lawns, mow often after moderate growth. For best cutting performance, grass over 6" (15 cm) in height should be mowed twice. Make the first cut relatively high, the second to the desired height. • The mowing result will be best with a high engine speed (the blades rotate rapidly) and low speed (the rider moves slowly). If the grass is not too long and dense, the driving speed can be increased without negatively affecting the mowing result. • The finest lawns are obtained by mowing often. The lawn becomes more even and the grass clippings more evenly distributed over the mown area. The total time taken is not increased as a higher operating speed can be used without poor mowing results. The mowing result is poorer because the wheels sink into the soft lawn, clumps build, and the grass clippings fasten under the cowling. • Hose the mower deck underside with water after each use. When cleaning, the mower deck shall be raised into the transport position. [. . . ] Normal wear, tear or abuse is not covered under warranty. Product must be returned to Charlotte with a warranty claim form. All care and maintenance instructions must be followed as stated by the manufacturer on the care label. The fit of the protective apparel/boot is not covered under warranty. [. . . ]