User manual HUSQVARNA PG 400

[. . . ] GB Operator's manual sure Please read the operator's manual carefully and make ES Manual de instrucciones You understand the instructions before using the machine. The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Inspection and/or maintenance should be carried out with the motor switched off and the plug disconnected. [. . . ] Some maintenance and service measures must be carried out by trained and qualified specialists. see instructions under the heading Maintenance. Check regularly that they function as they should. The machine must not be run with defective or disassembled safety equipment. Never use a machine that has been modified in any way from its original specification. Machinery should only be started when grinding heads are resting on the ground unless carrying out a testing procedure as outlined in this manual. The machine should not be started without the rubber dust skirt attached. It is essential a good seal between machine and floor be established for safety, especially when operating in dry grinding applications. During grinding, the machine must be connected to a vacuum cleaner to sucking off the dust. When changing the grinding discs ensure power supply to the unit is OFF by engaging the Emergency Stop button and the power-plug disconnected. After each grinding/polishing operation always remove the diamond tools. Make sure that the rubber skirt is intact and clean and that it seals tightly against the floor. damaged rubber skirt should always be replaced. Always raise the machine from the surface after use to prevent it from sticking to the floor due to the heat. Make sure the grinding head has stopped rotating before raising the machine. Diamond tools may be very hot after use. Leave machine to cool off before removing the diamond segments. Always use the machine mounted lifting eye when lifting. The machine should always be transported under cover limiting the exposed to natural elements ­ in particular rain and snow. Store the equipment in a lockable area so that it is out of reach of children and unauthorized persons. The machine should always be stored in a dry place when not in use. Shut down the machine and disconnect the power plug. [. . . ] Check that the emergency stop button is not pressed by turning it clockwise. Inspection and/or maintenance should be carried out with the motor switched off and the plug disconnected. Not enough diamonds under the machine (if grinding thick glue or soft floors, too few diamonds under the machine will greatly increase the load on grinder and operator). Usually also accompanied by high current draw by motor. [. . . ]