User manual HUSQVARNA PS50

[. . . ] DO know how to stop the saw quickly in case of an emergency. DO shut off the engine and allow it to cool before refueling. dO inspect the blade , flanges and shafts for damage before installing the blade. DO use only blades marked with a maximum operating speed greater than the blade shaft speed. [. . . ] Competent staff (qualifications, age, training) who have read and understood the manual in detail before starting work: any electrical, mechanical or other problem should be investigated by a qualified maintenance engineer (electrician, maintenance manager, approved dealer, etc . That the warnings and instructions marked on the machine are followed (adequate personal protection, correct use, general safety instructions, etc). That no modification, transformation or addition is detrimental to safety and that it is carried out without prior authorization from the manufacturer. That only genuine spare parts are used for repairs. The ground-saw only needs pushing to move it into position on the site. It is easy to move on its four wheels, without starting the motor. DO NOT DO NOT allow other persons to be near the saw when starting, refueling or when cutting. Sparks from the saw could cause a fire or an explosion. Allow blade exposure from the guard to be over 180 degrees. Leave the saw unattended with the motor running. Check before starting Please read the instructions for use prior to operating the machine for the first time. To change the oil, remove the disk, lower the saw to the lowest position and then place the tray by the drain outlet (L) [SEE FIG. Store in a safe place, out of reach of children Maintain tools carefully Repairs We carry out all repairs in the shortest possible time and at the most economical prices (see overleaf for our address). Periodically, tighten the nuts and bolts and particularly after the first few hours of use. For extremely dusty conditions you may have to clean the air filter element 2 to 3 times a day. Make sure the disc supports surfaces, the adaptor plates and the spindle are kept clean. The manufacturer declines all responsibility for loss or damage resulting from misuse or any modification, alteration or powering that does not conform to the manufacturer's original specifications. At the work station, the sound pressure level may exceed 85xdbx(A) In this case individual protection measures must be taken. When working in a limited or closed area, make sure that the ventilation is adequate. The exhaust gases contain carbon monoxide (exposure to this toxic gas can cause loss of consciousness and can be fatal). Store in a safe place out ot reach of children. Remove all adjustment tools and wrenches Store diamond tool in a safe place so it cannot be bent or damaged. [. . . ] The chassis, without removing them [SEE FIG. Tighten the tensioning nuts (N), these The instructions for use and spare parts found in this document are for information only and are not binding. As part of our product quality improvement policy, we reserve the right to make any and all technical modifications without prior notice. Reparation Ta kontakt med din återförsäljare, som står till tjänst och utför reparation inom kortast möjliga tid och till bästa möjliga pris. [. . . ]