User manual HUSQVARNA PZ6029D

[. . . ] Operator Manual Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. PZ6029D / 966476701 PZ29D BF / 966554801 P/N 115 326227 Rev B 05/06/11 In order to implement improvements, specifications and designs can be altered without prior notification. Note that no legal demands can be placed based on the information contained in these instructions. The use of other parts voids the warranty. Do not modify or install non-standard equipment to the unit without consent from the manufacturer. [. . . ] They are accessed by tilting the seat forward. The right hand fuses are a 10 amp ATO/ATC fuse for accessory connections and a 20 amp ATO/ATC fuse for the ignition switch and safety interlock system The engine harness has two fuses located near the engine starter on the left side of the engine. The engine harness fuses are a 30 amp Maxi fuse for the fan reversing module and cooling fan and a 50 amp Maxi fuse for the glow plugs. 8065-075 Main harness fuses located under the seat Fuel Shut Off Valve The fuel shut off valve is located on the right front side of the engine, below the air cleaner. The valve is off when the handle tab is turned perpendicular to the fuel line. 25 CONTROLS Refueling IMPORTANT INFORMATION It is recommended that fuel be added to both tanks on initial start up. Read the safety instructions before refueling. The machine has two fuel tanks, one on each side just behind the seat. The capacity for each tank is 6 gallons (11. 4 liters). Regularly check the fuel cap gasket for damage and keep the cap properly tightened. The use of low sulfur fuel or ultra low sulfur fuel is mandatory for when the unit is operated in areas regulated by the Environmental Protection Agency (EPA). Use No. 2-D S500 or S15 diesel fuel as an alternative to No. 2-D, and use No. 1-D S500 or S15 diesel fuel as an alternative to No. 1-D for ambient temperatures below 14 °F (−10 °C) to help insure good cold weather starting. Observe caution and fill the tank outdoors (see the safety instruction). 8065-007 Fuel tanks IMPORTANT INFORMATION To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the fuel tanks, start the engine and let it run until the fuel lines and injector are empty. See Storage Instructions for additional information. Never use engine or injector cleaners in the fuel tank or permanent damage may occur. WARNING!The engine and the exhaust system become very hot during operation. Allow engine and exhaust system to cool before refueling. WARNING!Do not store, spill or use diesel fuel near an open flame. 26 OPERATION Read the Safety Instructions section and the following pages if you are unfamiliar with the machine. will allow mower to start moving forward in a straight line. Pull back on control levers to the neutral position and mower should stop moving. Pull back slightly on control levers, this will allow mower to start moving backwards. Push forward on control levers to the neutral position and mower should stop moving. To turn to the right While moving in a forward direction, pull the right lever back towards the neutral position while maintaining the position of the left lever, this will slow the rotation of the right wheel and cause the machine to turn in that direction. [. . . ] Touch up damage to the paint and spray a thin layer of oil on the underside of the mower deck to avoid corrosion. 2. Inspect the machine for worn or damaged parts and tighten any nuts or screws that may have become loose. 3. Change the engine oil; dispose of properly. 4. Empty the fuel tanks or add a fuel stabilizer. [. . . ]