User manual HUSQVARNA QD92I

[. . . ] Never work while people, especially children, or pets are nearby. Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. While working, always wear substantial footwear and long trousers. Do not operate the equipment when barefoot or wearing open sandals. [. . . ] Engine oil should be to point of almost overflowing (fig. Engine oil capacity is about 1 1/4 pints (20 ounces). Be very careful not to allow dirt to enter the Engine when checking or adding oil or fuel. Use clean 30 or 10W-30 grade oil and store in approved, clean covered containers. (Do not use pressurized starting fluid, as severe internal engine damage may occur due to loss of lubrication. 5), use fresh, clean regular unleaded automotive gasoline. Starting the engine Starter handle Choke lever Spark plug wire Fuel Valve Shift lever indicator Drive control lever "disengaged" position Drive control lever "engaged" position Drive control release "unlocked" position Drive control release "locked" position Throttle control Handle grip Reconnect spark plug wire (fig. 8) 1/3 of the way towards the high speed position. 6) with one hand and grasp handle bar with other hand. Pull rope out slowly until engine reaches start of compression cycle (rope will pull slightly harder at this point). Pull rope with a rapid, continous, full arm stroke. To start tiller movement, push down on the drive control release and squeeze the drive control lever (fig. The drag stake should be raised when tilling in the counter rotating ( ) till position (fig. The drag stake should be lowered when tilling in the forward rotating ( ) till position (fig. To start tiller movement, push down on the drive control release and squeeze the drive control lever. Always release drive control lever before moving shift lever into another position. Tilling is digging into, turning over and breaking up packed soil before planting. Soil conditions are important for proper tilling. Tines will not readily penetrate dry, hard soil which may contribute to excessive bounce and difficult handling of your tiller. Hard soil should be moistened before tilling: however, extremely wet soil will "ball-up" or clump during tilling. Wait until the soil is less wet in order to achieve the best results. For easier handling of your tiller, leave about 8 inches of untilled soil between the first and second tilling passes. [. . . ] Drain fuel tank, run engine until gasoline in carburetor is used. While engine is still warm, drain oil from engine. Remove spark plug, pour one half ounce of clean engine oil into cylinder. Pull starter handle slowly several times to distribute oil. [. . . ]