User manual HUSQVARNA QD95I

[. . . ] Never allow children to operate the equipment. Never allow adults to operate the equipment without proper instruction. Keep the area of operation clear of all persons, especially small children, and pets. Thoroughly inspect the area where the equipment is to be used and remove all door mats, sleds, boards, wires and other foreign objects. [. . . ] Did you choose the correct drive belt for your tractor?Using the wrong length belt may cause premature bearing or belt failure. Be sure to lift up the front end of the engagement rod as shown when performing the next operation. Use the two front holes in the cable bracket if your tractor has a 42" mower deck. Use the two rear holes if your tractor has a 46" mower deck. Secure the cable housing guide (groove down) to the cable bracket using the original collar and a 5/64" hair cotter pin (DD). Hook the end of the clutch spring over the pin and secure it with a 1/4" washer (P) and a 5/64" hair cotter pin (DD). Two different length drive belts are included with your snow thrower. Tractors with manual attachment clutches and dual front deck suspension brackets use the 55" drive belt with #46989 printed on the outside of the belt. Remove the engine pulley keeper from the side of the tractor frame by removing the washer and nut that secure the keeper. Attach the new pulley keeper supplied with the snow thrower, reusing the original bolt, washer and nut. Place tension on the belt by pulling the left side tensioning chain out as far as the 3/32" hairpin cotter (FF) will allow. Secure the chain in this position by inserting a 1/8" hairpin cotter (EE) through the chain. IMPORTANT: Do Not assemble the "V" belt around the outside of the engine pulley keeper or the keeper bolt. Did you choose the correct drive belt for your tractor?Using the wrong length belt may cause premature bearing or belt failure. Hook the assembly's notched arms onto the two shoulder bolts you assembled to the inside of the tractor frame. Hanger brackets using two pivot lock pins (GG) and 1/8" hairpin cotters (EE). Place the lift handle into the lift bracket on the right side of the snow thrower. Fasten the handle to the bracket using two 5/16" x 1-3/4" hex bolts (B) and 5/16" Nylock nuts (Y). Tilt the snow thrower back down to the ground. Remove the nylon tie which fastens the auger drive belt to the discharge housing, leaving the belt assembled around the pulleys. [. . . ] Wash off any salt deposit which may have dried on the thrower and housing. Any bare metal that has become exposed should be painted or coated with a light oil to prevent rust. (The two hanger brackets and the two shoulder bolts may be left attached to the tractor frame. ) Remove the drive belt from the engine pulley. [. . . ]