User manual HUSQVARNA R148S

[. . . ] To cut the grass with the mulching system (no grass collection), lift the rear deflector panel and insert the cap by fixing it with the spring as shown in the figure. L Always operate with the deflector or grasscatcher in the correct position. l Always stop the engine before removing the grasscatcher or adjusting the height of cut. L Never place your hands or feet underneath the deck or into the rear grass discharge chute while the engine is running. [. . . ] D)Work only when there is sufficient light. E)Before mowing, remove all foreign objects from the lawn which may be thrown by the machine. While mowing, stay alert for any foreign objects which may have been missed. L Refuel outdoors only and do not smoke while refuelling. l Fill up the fuel tank before starting the engine. Under no circumstances open the fuel tank cap or add petrol when the engine is running or when it is still hot. L If the petrol has overflowed, do not under any circumstances start up the engine. Move the mower away from the area where fuel has bean spilt and avoid any source of possible ignition until the petrol fumes have dissipated. l Replace the fuel tank cap and tighten it down firmly. E)Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. F) When mowing, never run; you must always walk. G)Exercise extreme caution when turning or when pulling the lawn mower towards you. H)Particular precautions must be taken when mowing on slopes or downhill stretches: lUse appropriate antislip footwear. L Mow across the face of slopes, never up or down. L Take great care when changing direction. lDo not mow on excessively steep slopes. I)Never use the lawn mower unless the guards and safety devices (e. Deflector, grass catcher) are securely in position and in good condition. j)Ensure that the grass catcher and deflector are correctly located. Failure to do so may result in foreign objects being ejected by the blade. [. . . ] LFrequently remove the wheel screws clean whith petroleum and oil before replacing. Ball bearings must be greased before remounting. lFrequently check the blade for damage. LThe lawn mower must be checked by a SERVICE DEALER. [. . . ]