User manual HUSQVARNA R43 S

[. . . ] Further information may be obtained from your dealer or the supplier. If not used properly this lawnmower can be dangerous!This lawnmower can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this lawnmower. The operator is responsible for following the warning and safety instructions in this manual and on the lawnmower. [. . . ] Allow the engine to cool before storing in any enclosure. To reduce fire hazard, keep the engine, silencer, battery compartment and fuel storage area free of grass, leaves or excessive grease. If the fuel tank has to be drained, this should be done outdoors. Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blades and fixed parts of the machine. Fit the lower handle ensuring that the formed ends are located properly in corresponding slots either side of the lawnmower. Make sure that the Lower Pull Cord Guide is on the right-hand side when viewed from the rear. Pull the Operator Presence Control to release the brake on the engine. Locate cord in the pull cord guide on the lower handle. (B4) You must release the brake by pulling the OPC lever to the handle before pulling out the cord. Do not cut or separate the 3 parts of the grassbox screen. (C2) Fitting the Grassbox Screen to the Grassbox Lower Locate the tabs on the bottom of the grassbox screen into the slots in the base of the grassbox lower and push home. Do not fill the fuel tank while smoking. Do not fill the fuel tank while the engine is running. To avoid introducing dirt into the fuel system, wipe all grass and dirt from the petrol filler cap before unscrewing it. It is recommended that you fill the tank through a funnel with a filter. Please Note :- move the product away from the fuelling area before starting Please Note:- When starting the engine for the first time, fill with oil and petrol as described above in the Oil and Petrol section. Priming is usually unnecessary when restarting a warm engine. However, cool weather may require priming to be repeated. Starting the engine for the first time 1. Advance engine speed control to FAST ` ' as illustrated in the Use - starting and stopping section. Push primer bulb (F) firmly five times 3. Follow instructions in the Use - starting and stopping section. [. . . ] Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condition. If the blade is cracked or damaged replace it with a new one. Remove the cap from the charging point at the bottom of the wiring loom. After charging, disconnect the charger from the socket and charging point. [. . . ]