User manual HUSQVARNA R52A

[. . . ] No other warranties, express or implied, are contained herein. Your authorized representative checked the vehicle before it was delivered to you and will provide you a copy of the completed vehicle warranty registration form. Husqvarna is not liable for errors in this manual or for incidental or consequential damages that result from the use of the material in this manual. This manual contains proprietary information that is protected by copyright. [. . . ] See Vehicle Load Capacities on page 28 for vehicle capacity information. Parking the vehicle with a trailer on a hill should be avoided. If you must park on a hill, apply the brakes and have someone chock the trailer tires. The brakes should be released to allow the chocks to absorb the trailer load. After the trailer tires have been chocked, engage the park brake. TRANSPORTING ON A TRAILER WARNING • Gasoline vehicles only: Turn fuel shut-off valve to the closed (OFF) position (Figure 14). • Do not allow riders in the trailer being towed. • Avoid sudden starts, sudden stops, and tight turns when towing. WARNING CONTINUED ON NEXT PAGE HUV 4421 Owner’s Manual Page 29 Storage WARNING • Avoid stopping on a hill when towing. If you must stop on a hill, avoid sudden starts, or rolling backwards and stopping suddenly. Failure to heed this warning could cause the vehicle to overturn, possibly resulting in severe personal injury. • Reduce normal driving speed when transporting a vehicle on a trailer. • For use on public roads, the trailer must meet all federal, state, and local requirements such as taillights, brake lights, etc. Check electrolyte level after charging and add distilled water if necessary. If the battery is dead, see Using A Booster Battery (Jump Starting) on page 52. Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL position. Gasoline vehicles: Prepare the fuel tank. Following the manufacturer’s directions, add a commercially available fuel stabilizer (such as Sta-Bil®). Run the engine in a well-ventilated area to allow treated fuel to replace untreated fuel in the carburetor. Disconnect the fuel vent line from the fuel tank vent nipple (Figure 34). Plug the fuel tank vent nipple so that it is air tight. Husqvarna recommends using a slip-on vinyl cap. Remove both spark plugs, and pour 1/2 ounce (14. 2 mL) of SAE 10 weight oil through each of the two spark plug holes. Rotate the engine crankshaft by hand several times, then install both spark plugs. [. . . ] The warranty period is two years from the date of purchase. COVERAGE: Subject to certain conditions and exclusions as stated below, the warranty on emission-related parts is as follows: (1) Any warranted part that is not scheduled for replacement as required maintenance in the written instructions supplied, is warranted for the warranty period stated above. If the part fails during the period of warranty coverage, the part will be repaired or replaced by HUSQVARNA according to subsection (4) below. Any such part repaired or replaced under warranty will be warranted for the remainder of the original warranty period. [. . . ]