User manual HUSQVARNA ROYAL 36 EL

[. . . ] Operator's Manual Read the operator's manual carefully and make sure that you understand the contents before using the lawnmower. Read operating instructions carefully before using the mower. The manufacturer reserves the right to carry out product modifications without further notice. Guarantee, complaint Guarantee and complaint matters are dealt with in accordance with the Sale of Goods Act. [. . . ] Do not use your lawnmower until you are sure that the entire lawnmower is in a safe operating condition; - if the lawnmower starts to vibrate abnormally. Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition. Only use the replacement blade, blade bolt, spacer and impeller specified for this product. Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blades and fixed parts of the machine. Pull the tie spindle bar (A1) to one side so that it is flush with hole in the side of the moulding. Push the tie bar back through the locating hole in the handle and secure it with a handle knob (A). Repeat the sequence for the other side of the handle. fitting the Upper Handle to the Lower Handle 1. Make sure the switchbox is on the right hand side when viewed from the rear. Fit the cable to the handles with the clips provided making sure the cable is not trapped between the upper and lower handles. Align the matching tabs and slots in the back and sides of the grassbox screen and press firmly together (E2). Lower the assembled screen into the grassbox, aligning the tabs with the slots in the grassbox and press firmly together (E4, E5). Take the lid, align the tabs with the slots and press firmly together (E6). Make sure the discharge chute is clean and free from debris. Fit the 2 location studs on the safety flap into the 2 location holes on the grassbox lid and ensure the grassbox is securely located (F). IMPORTANT After fitting ensure no gap remains between the safety flap and grassbox lid. Removal is the reverse procedure Where grass collection is not required you can use the lawnmower without the grass collector. Secure the lower handle with the handle knobs provided. Make sure the switchbox is on the right hand side when viewed from the rear. Fit the cable to the handles with the clips provided making sure the cable is not trapped between the upper and lower handles. Form loop in mains cable and push the loop through the slot as illustrated in picture G1. To secure, position loop over the hook and pull the cable back through the slot as illustrated in picture G2. [. . . ] Lift the grass collection indicator cover, remove the ball and brush clean, replace ball and cover after cleaning (W2). Wipe over the surface of your lawnmower with a dry cloth. IMPORTANT Never use water for cleaning your lawnmower. Do not clean with chemicals, including petrol, or solvents - some can destroy critical plastic parts. [. . . ]