User manual HUSQVARNA ROYAL 46 RC

[. . . ] Further information may be obtained from your dealer or the supplier. If not used properly this lawnmower can be dangerous!This lawnmower can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this lawnmower. The operator is responsible for following the warning and safety instructions in this manual and on the lawnmower. [. . . ] Stop the engine, and wait until the blade has stopped:before leaving the mower unattended for any period; before refuelling 22. Stop the engine, wait until the blade has stopped and disconnect the spark plug lead:before clearing a blockage; before checking, cleaning or working on the appliance; if you hit an object. Do not use your lawnmower until you are sure that the entire lawnmower is in a safe operating condition. Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off valve, turn the fuel off at the conclusion of mowing. Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition. Only use the replacement blade, blade bolt, spacer and impeller specified for this product. Never store the lawnmower with fuel in the tank inside a building where fumes can reach an open flame or spark. Allow the engine to cool before storing in any enclosure. To reduce fire hazard, keep the engine, silencer, battery compartment and fuel storage area free of grass, leaves or excessive grease. If the fuel tank has to be drained, this should be done outdoors. Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blades and fixed parts of the machine. Starting the engine for the first time 1. Advance engine speed control to FAST as illustrated in the Use - starting and stopping section. Move engine speed control to FAST Push primer bulb (H) firmly five times Position and push primer bulb firmly three times before starting engine. (if engine stopped because it ran out of fuel, refuel engine - push primer bulb three times. Follow instructions in the Use - starting and stopping section. If engine fails to start after three pulls of the pull cord, push primer bulb three times and repeat step 3. Move the Engine Speed Control to the FAST `+' position before starting. Pull the operator presence control (OPC) to release the brake on the engine and the J2 blade. Pull the recoil starter fully towards you until you feel the full resistance, return the handle slowly then pull the handle firmly towards you to its full extent. After the engine has J3 started, allow to run for 30 seconds before commencing to use. Forward drive is engaged and disengaged with the Powerdrive lever at the top of the handle (J4). [. . . ] Please note If you have a machine fitted with BBC then you must remove both blade bolts with a hexagonal drive key. Always handle the blade with care - sharp edges could cause injury. USE GLOVES Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condition. If the blade is cracked or damaged replace it with a new one. [. . . ]