User manual HUSQVARNA ROYAL 50 S BBC

[. . . ] Read the operator's manual carefully and make sure that you understand the contents before using the lawnmower. Read operating instructions carefully before using the mower. The manufacturer reserves the right to carry out product modifications without further notice. Guarantee, complaint Guarantee and complaint matters are dealt with in accordance with the Sale of Goods Act. [. . . ] Locate safety flap onto the top of the grassbox. Please Note :- Ensure no gap remains between the safety flap and the grassbox Where grass collection is not required you can use the lawnmower without the grassbox. Ensure the safety flap is fully closed Check oil level periodically and after every five hours of operation. Add oil as necessary to keep the level to the FULL mark on the dipstick. Use a good quality SAE 30 four stroke oil. To fill with oil:F1 a) Remove oil filler cap. Change the oil after the first five hours operation and thereafter every 25 F2 working hours. Always change the oil while the engine is warm - but not hot never attempt any maintenance on a hot engine. Use fresh regular grade lead free petrol. Do not fill the fuel tank when the engine is hot. Do not fill the fuel tank while smoking. Do not fill the fuel tank while the engine is running. To avoid introducing dirt into the fuel system, wipe all grass and dirt from the petrol filler cap before unscrewing it. It is recommended that you fill the tank through a funnel with G2 a filter. Please Note :- move the product away from the fuelling area before starting Please Note:- When starting the engine for the first time, fill with oil and petrol as described above in the Oil and Petrol section. Priming is usually unnecessary when restarting a warm engine. However, cool weather may require priming to be repeated. Starting the engine for the first time 1. Advance engine speed control to FAST as illustrated in the Use - starting and stopping section. Move engine speed control to FAST Push primer bulb (H) firmly five times Position and push primer bulb firmly three times before starting engine. (if engine stopped because it ran out of fuel, refuel engine - push primer bulb three times. Follow instructions in the Use - starting and stopping section. [. . . ] If the engine will still not start, immediately disconnect the spark plug lead. If the engine will still not turn over, immediately disconnect the spark plug lead. Disconnect the spark plug lead and allow the engine to cool down. Clean grass clippings and debris from around the engine and air inlets and the underside of the deck including the chute. [. . . ]