Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HUSQVARNA ST261 E. We hope that this HUSQVARNA ST261 E user guide will be useful to you.
Lastmanuals help download the user guide HUSQVARNA ST261 E.
Detailed instructions for use are in the User's Guide.
[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly. Never allow children to operate the equipment. [. . . ] Check engine oil level (Q) The engine on your snow thrower has been shipped, from the factory, already filled with oil. Check engine oil with snow thrower on level ground. Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw tight, wait for a few seconds, remove and read oil level. If necessary, add oil until "FULL mark on dipstick is reached. To change engine oil, see "TO CHANGE ENGINE OIL in the Maintenance " section of this manual. If temperature is above 10°C (50°F), priming is not necessary. NOTE: Over priming may cause flooding, preventing the engine from starting. If you do flood the engine, wait a few minutes before attempting to start and DO NOT push the primer. When the engine starts, release the recoil starter handle and slowly move the choke control to the "OFF" position. Allow the engine to warm up for a few minutes. Engine will not develop full power until it has reached normal operating temperature. WARM START - RECOIL STARTER Follow the steps above, keeping the choke (E) in the "OFF" position. If the recoil starter has frozen and will not turn the engine, proceed as follows: 1. Grasp the recoil starter handle and slowly pull as much rope out of the starter as possible. Release the recoil starter handle and let it snap back against the starter. If the engine still fails to start, repeat the above steps or use the electric starter. Run the engine for a few minutes to help dry off any mois33 ture on the engine. Always operate the snow thrower with the engine at full throttle. full throttle offers the best snow thrower performance. Go slower in deep, freezing or heavy wet snow. Use the drive speed control, NOT the throttle, to adjust ground speed. It is easier and more efficient to remove snow immediately after it falls. [. . . ] WARNING: Never store the snow thrower with gasoline in the tank inside a building where fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or gas appliance. Allow the engine to cool before storing in any enclosure. When snow thrower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Clean entire snow thrower (See "CLEANING" in the Maintenance section of this manual). [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE HUSQVARNA ST261 E
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HUSQVARNA ST261 E will begin.
