User manual HUSQVARNA SWEEPER 960

[. . . ] Dust forms when grinding, which can cause injuries if inhaled. Starting: Reduce the pressure between grinding disc and floor by pushing down on the handle without raising the grinding unit off the ground. This product is in accordance with applicable EC directives. Symbols on the product or its packaging indicate that this product cannot be handled as domestic waste. [. . . ] Be careful as clothing, long hair, and jewellery can get caught in moving parts. Never leave the machine unsupervised with the motor running. Make sure that there is always another person close at hand when you use the machines, so that you can call for help if an accident should occur. Always ensure you have a safe and stable working position. There is always a risk of shocks from electrically powered machines. Avoid unfavourable weather conditions and body contact with lightning conductors and metal objects. Never drag the machine by means of the cord and never pull out the plug by pulling the cord. Keep all cables away of water, oil and sharp edges. Make sure the cable is not pinched in doors, fences or the like. Check that the cables are intact and in good condition. Never use the machine if any cable is damaged, but hand it in to an authorized service workshop for repair. Leave machine to cool off before removing the diamond segments. Always use the machine mounted lifting eye when lifting. The machine should always be transported under cover limiting the exposed to natural elements ­ in particular rain and snow. Store the equipment in a lockable area so that it is out of reach of children and unauthorized persons. The machine should always be stored in a dry place when not in use. Shut down the machine and disconnect the power plug. Have a set of gloves ready, as diamond tools can get very hot. Pull back on handle to lift grinding head off the ground. The locking knobs should be positioned in-line with the handlebar to reduce the risk of damaging the knobs when laying down the machinge when changing tools. Once new diamond segments have been attached, reverse procedure to lower machine to ground. It is highly recommended to use the Husqvarna DC 3300 dust extraction system for complete dust control. [. . . ] ), the concrete will behave as if it has a low compressive strength and therefore, require a hard bond segment. Epoxy coatings, ceramic tile adhesives, levelling compounds/screeds) will often have a larger bearing on what diamond to select, than will the compressive strength of the concrete. As a general rule, when grinding a concrete slab for the first time and you are unsure about its hardness, always begin with harder bond diamonds under the machine. This will ensure the least amount of wear on the diamond segments. [. . . ]