User manual HUSQVARNA T85 HX

[. . . ] Clear the area of objects such as rocks, toys, wire, etc. , which could be picked up and thrown by the blade. Be sure the area is clear of other people before mowing. Do not mow in reverse unless absolutely necessary. Always look down and behind before and while backing. [. . . ] • Recharge at 6-10 amperes for 1 hour. NOTE: The original equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary. TO CLEAN BATTERY AND TERMINALS Corrosion and dirt on the battery and terminals can cause the battery to “leak” power. • Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor. • Rinse the battery with plain water and dry. • Clean terminals and battery cable ends with wire brush until bright. • Coat terminals with grease or petroleum jelly. • Reinstall battery (See “REPLACING BATTERY" in the 18 SERVICE AND ADJUSTMENTS section of this manual). FLAT WASHER HEX BOLT (GRADE 8)* LOCK WASHER *A GRADE 8 HEAT TREATED BOLT CAN BE IDENTIFIED BY SIX LINES ON THE BOLT HEAD. 14 CUSTOMER RESPONSIBILITIES V-BELTS Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. Replace a dirty, bent, or damaged cartridge. TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE FIG. 16 NOTE: Although multi-viscosity oils (5W30, 10W30 etc. ) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil. Change the oil after every 50 hours of operation or at least once a year if the tractor is not used for 50 hours in one year. Check the crankcase oil level before starting the engine and after each eight (8) hours of operation. Tighten oil fill cap/ dipstick securely each time you check the oil level. 16 and 17) Determine temperature range expected before oil change. All oil must meet API service classification SF-SJ. • Be sure tractor is on level surface. • Oil will drain more freely when warm. • Catch oil in a suitable container. [. . . ] Bolt Carriage 5/16-Unc 1/2 Reinforcement Mandrel Ring Mandrel Asm (Includes Key Nos. 810, 13-15, 31 and 33) Mower Asm Service (Std. Deck Order separately all Nose Roller components) NOTE: All component dimensions given in U. S. inches 1 inch = 25. 4 mm 45 SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION SIGHTING GUIDE CUT OUT ON D THIS OTT IS A ED L 15° S INES LOP E ONLY RIDE UP AND DOWN HILL, NOT ACROSS HILL SIGHT AND HOLD THIS LEVEL WITH SKY LINE OR TREE. 46 15° MAX. Operate your Tractor up and down the face of slopes (not greater than 15°), never across the face. [. . . ]