User manual HUSQVARNA TB1000

[. . . ] Designation Instructions and parts pouch + bolts bag Motor block and battery Stand support plates Transport wheels + stand Left-hand protective wing Right-hand protective wing Steering bars assembly Charger Right-hand lower steering bar Left-hand lower steering bar Disc earth drills Initial earth drills WARNING: Assembling this machine wrongly can cause severe injury. You must fit the stand supports, the transport wheel, the earth drills, the steering bars assembly and the earth drill protection wings. You will only need a few minutes to do this if you follow the instructions. â· First remove all the items from the box. [. . . ] Always remove the safety cut-out any time that the machine will be left unobserved. The operator must pay particular attention on hard or stony ground because the machine has the tendency to be much less stable than on cultivated ground and use slow speed for ploughing. Never lift or transport a machine while it is still switched on. Use the transport wheel and a ramp to lift the machine into a vehicle or onto a trailer. Maintenance / Storage / Accessories Before storing the machine in a confined or closed space, let it cool down for at least 5 minutes. Keep the nuts, bolts and screws tightened to ensure that the equipment is in a safe operating condition. Regular servicing is essential for safety and for maintaining the level of performance. To reduce the risk of fire, keep the motor, the battery compartment and the storage area clear of vegetation and surplus grease. Switch the machine off by removing the safety cut-out in the following cases: - Before working on the tools. - Before any cleaning or checking operations , or repairs to the machine. - If you bump into a foreign body, inspect the machine to check whether it is damaged. Make any necessary repairs before using it again. - If the machine starts to vibrate abnormally, immediately seek cause of the vibration and make the necessary repairs or ensure that they are carried out. The machine may be used with certain accessories. It is the owner's responsibility to ensure that these tools or accessories are certified as being in accordance with the prevailing safety regulations. The use of uncertified accessories may jeopardise your safety. Do not pull a trailer with this machine. Always remove the safety cut-out before performing any leaning operations. use a damp cloth for cleaning and servicing. Handle the battery carefully so as not to create a short circuit between conductive materials such as, necklaces, rings, bracelets or keys. In the event of a short circuit, the battery or the conductive materials may overheat and cause burns. do not use solvents or petroleum-based products. [. . . ] WARNING For safety and economy reasons, the machine switches off automatically after 40 seconds and the green LED goes out. WARNING The maximum power button (6) must only be used for brief periods. Hold down the safety lever (2) and then pull the trigger (3) on the right-hand handle to set the earth drills in rotation. There are two speeds, one for movement by pulling the trigger (3) halfway and one for operating mode, with the trigger (3) pulled back fully. [. . . ]