User manual HUSQVARNA TR430

[. . . ] Never remove the cap of the fuel tank or add petrol while the engine is running or when the engine is hot; - if petrol is spilled, do not attempt to start the engine but move the machine away from the area of spillage and avoid creating any source of ignition until petrol vapors have dissipated; - replace all fuel tank and container caps securely. Before using, always visually inspect to see that the tools are not worn or damaged. Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. Do not change the engine governor settings or overspeed the engine. [. . . ] Pull rope with a rapid, continous, full arm stroke. keep a firm grip on the starter handle and let rope rewind slowly. Do not let starter handle snap back against starter. 7) and then move to fully opened position as engine warms up. 9) to the slow position for a few minutes to warm up engine. Keep drive control bar in "disengaged" position when starting the engine (fig. In order to idle smoothly, a new engine may require 3 to 5 minutes running time above slow idle speed. Idle speed has been adjusted to be correct after this break-in period. Always release drive control bar before moving shift lever into another position. Don't back yourself into a solid obstruction such as a tree, fence, etc. To stop engine, move throttle control (fig. 10) to slow position and allow the engine to run at low speed for 1 or 2 minutes before moving throttle to stop position. 10) slowly and return the handle to its original position when reistance is felt. This operation is necessary to prevent outside moist air from intruding into the combustion chamber. Lift handle to raise tines out of the ground (fig. Swing the handle in the opposite direction you wish to turn, being careful to keep feet and legs away from the tines. When you have completed your turn-around, lower the handle. 10) are slotted so that they can be raised for deep tilling and lowered for shallow tilling to protect small plants from being buried. Lower the depth stake to its lowest position and insert the depth stake pin in the topmost hole. Always release drive control bar before moving shift lever into another position. Tilling is digging into, turning over and breaking up packed soil before planting. Soil conditions are important for proper tilling. [. . . ] Choked improperly, flooded engine Move choke control to "RUN" position or place throttle control in "FAST" position and pull starter several times to clear out gas. Dirty air filter Remove and clean or replace. Water in gasoline or old fuel Drain fuel tank and carburetor, use fresh fuel and replace spark plug. Engine misses or lacks power Spark plug dirty, improper gap or wrong type Replace spark plug and adjust gap Poor compression Major engine overhaul. [. . . ]