User manual HUSQVARNA TS 100 R

[. . . ] Before leaving our factory every machine passes an exacting inspection programme in which everything is checked minutely. Following the instructions will ensure that your machine gives long service, in normal operating conditions. The user advice and spare parts mentioned in this document are given as an indication, and do not constitute an undertaking. No warrantee will be granted in the event of errors or omissions, or for damage occurring during delivery, or caused by the design or use of the machine. [. . . ] The working area must be completely cleared, well lit and all safety hazards removed (no water or dangerous objects in the vicinity) The operator must wear protective clothing appropriate to the work he is doing. We recommend that this includes both eye and ear protection The use of ear protection is mandatory. Any persons not involved in the work should leave the working area Use only blades marked with a maximum operating speed greater than blade shaft speed Release the two knobs (23), remove them and then remove the guard. Take care about the direction of rotation which is shown by an arrow on one of the faces. Make sure the contact faces of flanges, of blade and the axle are clean. - Make sure that the mains voltage corresponds with that marked on the manufacturer's plate on the machine. - Three-phase motor : Make sure that the motor rotates in the same direction as the arrow stamped on the casing: if the motor does not turn in the direction required, swap two of the supply wires. - Use the following types of plug, single phase 2 P + E, or 3xPx+xE / 3xPx+xNx+xE according to the corresponding voltage. - ELECTRICAL SAFETY : Operate this machine only on a supply equipped with a 30 mA earthed current-limiting circuitbreaker. Otherwise, consult our catalogue for appropriate models. - The RCCB must be used correctly, including testing it regularly. For tools supplied with an integral RCCB in the cable or in the mains plug, if the cable or plug has been damaged, repairs must be carried out by the manufacturer, one of his agents or by a qualified repair workshop to avoid any risks resulting from errors. - Extension lead : Cable size sufficient for the electrical power, connection to the mains by a H07 RNF type cable of the following size : - 3 x 2. Get into a comfortable, balanced position. Always keep blade guard in place · for wet cutting: · Fill the tray with clean water (maximum level = base of the plate). As each saw is fitted with a selfpriming pump, the disk is sprayed as soon as the saw is turned on. Engines : - Standard : with on-off switch with no-volt release switch - 1-phase, 230 V, 2-3 hp 3 x 1. 5 mm2 with plug (cable 2 P + E) - 3-phase , 400 V , 3-4 hp 4 or 5 x 1. 5 mm2 without plug (cable 3P+E) - Optional : with cut-out switch with or without ammeter - 1-phase, 110 V, 2 hp 3 x 2. Always tilt the cutting head before tilting the tables to avoid the tables colliding with the disc (SEE FIG. Re-levelling: - Lift the large table from the front (SEE FIG. - Return the cutting head to the straight cutting position. [. . . ] WARRANTY The warranty is limited to the free of charge replacement of parts recognised as defective by Husqvarna (excluding wear components and consumables) providing the repair is made within after-sales service of Husqvarna or a recognised Husqvarna repair centre. The manufacturer is not responsible for any direct or indirect, material or immaterial, damages caused to persons or things by failure of the machine or the non operation of the machine. WARRANTY CONDITIONS To benefit the warranty, it is necessary to return the joined warranty certificate, duly completed, to Husqvarna within eight days of the purchase. In case of failure of the machine during the warranty period, our after-sales services will inform you of the appropriate and most effective method of dealing with your claim and advise you if necessary of your nearest approved service centre. [. . . ]