User manual HUSQVARNA TS 300 E

[. . . ] Be careful to keep electric cables and water hose clear of the setting screw located at the back. 3- Tilt the head of the machine to clear the centering pin. 4- Remove the head by pulling it toward the front to clear the axis of the head from the lower arm hole of the TS300E. 5- Insert the head spindle into upper hole of the TS 300E. [. . . ] Use of a diamond disc for water lubricated cutting of marble, stone, granite, brick and facings (porcelain, glazed tiles, ceramics, etc). The use of any other disc is forbidden (abrasive, saw, etc). Competent personnel (qualifications, age, training, education) who have studied the manual in detail before starting work: any fault of an electrical or other nature must be checked by a competent person (electrician, maintenance foreman, authorized dealer, etc). That the warnings and instructions marked on the machine are followed (adequate personal protection, correct use, general safety instructions, etc). That no modification, transformation or addition is detrimental to safety and that it is carried out without prior authorization from the manufacturer. That only genuine spare parts are used for repairs. check the supply cable lead periodically. Use : Sawing marble, stone, granite, brick, cement and all facings (porcelain, glazed tiles, ceramics, etc). Any application not corresponding with the intended use (use of a saw blade, abrasive disc, etc) is prohibited. Please read the instructions for use prior to operating the machine for the first time. - Make sure that the mains voltage corresponds with that marked on the manufacturer's plate on the machine. - Three-phase motor Make sure that the motor rotates in the same direction as the arrow stamped on the casing: if the motor does not turn in the direction required, swap two of the supply wires. - Use the following types of plug, single phase 2 P + E, or 3xPx+xE / 3xPx+xNx+xE according to the corresponding voltage. The use of ear protection is mandatory. The operator must wear protective clothing appropriate to the work he is doing. We recommend that this includes both eye and ear protection. The working area must be completely cleared, well lit and all safety hazards removed (no water or dangerous objects in the vicinity). Any persons not involved in the work should leave the working area. [. . . ] At the work station, the sound pressure level may exceed 85 db (A) In this case individual protection measures must be taken. CAUSES Not plugged in properly or cable damaged REMEDIES - Make sure that the supply is correctly plugged in (plug, extension lead, etc) - Check the supply cable - Test or have tested by an electrician (circuit breaker, plug, etc) - Have tested by an electrician or contact the service department - Contact the service department to have the motor replaced Contact your supplier who is entirely at your service to carry out repairs in the shortest time at the best possible price. CAUSES Single phase motor starting condenser Three-phase supply not correct (on 2 phases, motor cable faulty) REMEDIES - Replace the condenser - Have it checked by an electrician or contact the service department For rapid delivery of spares and in order to avoid any wasted time, it is necessary to remind your supplier of the details shown on the instruction plate on the machine with each order, as well as the reference of the part to be replaced. CAUSES The mains lead is not correctly connected or is damaged No voltage in pump circuit or mains supply circuit REMEDIES - Check the mains lead In the event of deterioration and scrapping of the machine, the following items must be disposed of in accordance with the requirements of the legislation in force. [. . . ]